Abstract:Thermal fatigue is a potentially significant degradation mechanism in Nuclear Power Plants (NPP). For the fatigue analysis, the thermal load information about components must be determined firstly. In this paper, an experimental study was carried out to obtain local fluid temperatures and local heat transfer coefficients for the safety injection nozzle component in reactor coolant system (RCS). In this mixing tee component a hot jet issues into a cold cross-flow stream from an oblique pipe and the turbulent mixing of two fluids induces local cycling stresses on the adjacent piping wall. Experiments were performed using a special-made heat fluxmeter, which can measure the mixed fluid temperature close to the wall and the heat transfer coefficient between the fluid and the wall. Plexiglass and metallic 1/9-scale mockups were manufactured for flow visualization and heat transfer tests, respectively. All tests were conducted at range of 0–40 for the jet-to-cross-flow velocity ratio. The flow visualization test has obtained general pattern of the flow and identified sensitive zones in the component where the jet and cross-flow interact intensively to cause thermal fatigue more possibly. In the heat transfer test, heat fluxmeters were positioned in the wall at these sensitive zones. The measurement results of temperatures and heat transfer coefficients have been discussed in detail in the paper. These experimental results allow us improving the state of knowledge of the thermal load to be used in the industrial mixing tees in operating for long lifetime assessment and for the design in the basic Nuclear Power Plants.

Experimental Study on Heat Transfer Characteristic of T-Junction in Cooling System of PWR

Numerical and Experimental Investigation of Flow and Heat Transfer in a T-Junction with Thermal Sleeve

Digital Particle Imaging Velocimetre Experimental Study of the Jet-to-Crossflow in a T-Junction with a Sleeve Tube

Numerical Simulation of Non-isothermal Jetinto Crossflow for T-junction Pipe with Thick Wall

Experiment Research on Thermal Mixing in Horizontal T-Junction: In-Pipe Temperature and Flow Characteristic Research

Experimental Investigation on Heat Transfer Characteristics in a Safety Injection Nozzle Component in PWR

Experimental Observations of Thermal Mixing Characteristics in T-Junction Piping

Study on Near Wall Temperature Variation of Heated Jet in Crossflow

Numerical Simulation of Transient 3-D Turbulent Heated Jet into Crossflow in a Thick-Wall T-junction Pipe

Heat Transfer Characteristic of Water at Near Critical Pressure in Circumferentially Non-Uniformly Heated Vertical Tubes

Selection of the Velocity Ratio in Pressurized Water Reactor T-junction Components Subject to Thermal Shock

Investigation on Heat Transfer Characteristics of Ultra-Supercritical Water in Vertical Upward Internally Ribbed Tube

Measuring Method of Inner Wall Temperature Fluctuations for Thermal Fatigue in T-junction Pipe

Experimental Investigation on Heat Transfer Characteristics of High Pressures Water in a Vertical Upward Annular Channel

Investigation on the Heat Transfer Characteristics of the Steam-Water Two-Phase Flow in the Inclined Upward Smooth Tube in Sub-Critical and Near Critical Pressure Regions

Experimental Investigation on Heat Transfer Characteristics of Water in Vertical Upward Tube under Supercritical Pressure

Numerical Study on Flow and Heat Transfer Characteristics in the Rod Bundle Channels under Super Critical Pressure Condition

Experimental Investigation on Heat Transfer Characteristics of Smooth Tube with Downward Flow

Numerical study on heat transfer characteris tics of supercritical water in straight and helical tubes

Investigating Thermal Mixing and Reverse Flow Characteristics in A T-Junction by Way of Experiments

Experimental Study on the Pressure Drop and Heat Transfer Characteristics of Tubes with Internal Wave-Like Longitudinal Fins