Abstract:Flapping flight has undoubtedly played a significant role in many of the aeronautical engineering achievements in the past several centuries. Flapping motions of wings/fins are used by animals (such as birds, insects and bats) to generate lift or thrust to keep them aloft in the surrounding fluid. Researches in this area are not only motivated by the fundamental interest of understanding the mechanism of flapping flight, but also the development of Micro Air Vehicles (MAVs) based on biomimetics. In this lecture, we will address our efforts towards both experimental studies and virtual testing of flapping flight with our High End Digital Prototyping (HEDP) system. The aim of our research is to use physical and biological models to drive the engineering design of these vehicles. Firstly, two types of flapping-wing Unmanned Air Vehicles (UAVs) with spatial four-bar drive mechanism will be presented, including the wind tunnel experiment and prototype flight test results. Secondly, various computation approaches have been adopted to simulate the flapping motions, including traditional moving mesh techniques based on Arbitrary Lagrangian Eulerian (ALE) formulation, and Lattice Boltzmann method with immersed boundary methods. For a single wing-system, we have investigated the influences of various parameters on both the symmetric flapping and asymmetric flapping with bird-like or turtle-like flapping mode. For a tandem wing system, we have investigated the interaction between the hind wing and the vortex shedding off the fore wing and learned how to utilize the flow mechanism to achieve better aerodynamic performances. Moreover, Dynamic Mode Decomposition (DMD) algorithm has been adopted to reveal the underlying physics due to its capability and accuracy in analyzing the complex transient systems. Finally, the flight control design of a dragonfly-like Flapping Wing Micro Aerial Vehicle (FWMAV) is presented, which has incorporated a Linear-Quadratic Regulator (LQR) method and an Iterative Learning Tuning (ILT). In general, we expect that these virtual testing by computational simulations and flight control can drive the design of our next generation flapping-wing UAVs in the future.

Blade dynamics measurement for micro helicopter using laser

Experimental Studies For Micro Helicopter Blade Dynamics

Research on high-speed and non-contact angle detection based on laser measurement

A Non-Contact Dynamic Attitude Measurement System Based on 3D Oblique Laser Doppler Vibrometers

Laser Dynamic Testing System of Helicopter Rotor Blade Flap and Lag Angles

Laser and vision-based measurements of helicopter blade angles

Flight Test System for Measuring the Aerodynamic Parameters of Rotor Blades

Towards Virtual Testing of Flapping Flight

An Optoelectronic System For The In-Flight Measurement Of Helicopter Rotor Blades Motions And Strains

High‐resolution Method for Measuring the Torsional Deformation of a Dragonfly Wing by Combining a Displacement Probe with an Acousto‐optic Deflector

Distance Measurement of Contra-Rotating Rotor Blades with Ultrasonic Transducers

A dynamic turbine tip clearance measurement method based on laser self-mixing interferometric ranging considering Doppler effect

Test Verification for Improved Design of Rotor Blade by ESPI

Transverse vibration of the blade for unmanned micro helicopter using Rayleigh-Ritz method

Helicopter main rotor angular velocity analysis by laser Doppler velocimetry: simulation and experimental results

Analysis and experimentation of novel asymmetric photo-thermal micro-actuator

Divergent-Ray Projection Method for Measuring the Flapping Angle, Lag Angle, and Torsional Angle of A Bumblebee Wing

Measurement of the Flapping Angle and Torsional Angle of a Dragonfly Wing Using Fringe Projection Method

Simulation and parameter extraction of flying‐bird motion echo based on laser micro‐Doppler effect

Monitoring the Dynamics of a Helicopter Main Rotor With High-Speed Stereophotogrammetry

Fringe Projection Profilometry for Three-Dimensional Measurement of Aerospace Blades