Abstract:Journal of Vibration and Control, Ahead of Print. Wind turbine design and operation will benefit from a better understanding of blade dynamics. Usually, only one surface or one side of a 3D structure is measured in Scanning Laser Doppler Vibrometer (SLDV) tests due to test setup and instrumentation limitations. However, in this work, we demonstrate an approach to overcome these limitations while also using an SLDV that provides high spatial resolution measurement. In the case of a wind turbine blade, only one surface is typically measured; however, it is beneficial to investigate both blade global modes and the relative motions of the two blade surfaces by using both numerical models and experimental tests. This work creatively develops both experimental and numerical approaches to investigate the dynamics and the relative motions of both surfaces of the wind turbine blade from global and local perspectives. On the experimental side, experimental modal testing is conducted on both surfaces of the wind turbine blade with a high spatial resolution 3D SLDV. The two surfaces of the wind turbine blade are measured and stitched together to build the blade experimental mode shapes of both surfaces. A total of over 1500 points are scanned from both surfaces of the blade in a non-contact fashion to obtain not only the global bending modes (flap-wise and edge-wise), the global torsional modes, but also the localized panel mode shapes. On the numerical side, a finite element model of the blade is developed to obtain the numerical mode shapes. The experimental mode shapes on either one surface or both surfaces of the blade are used to validate the blade finite element model. The mode shape correspondence between the model and the test is also identified. With the availability of both experimental and numerical mode shapes, localized panel modes of the wind turbine blade are observed and characterized, and as a result the numerical model is validated. This work provides useful case studies for the design and structural analysis of wind turbine blades based on both the experimental observations and the validation of numerical models typical of those used for blade design and blade structural analysis.

Experimental Studies For Micro Helicopter Blade Dynamics

Blade dynamics measurement for micro helicopter using laser

Experimental Study to Quantify the Rotor-to-Rotor Interaction Characteristics of a Small Unmanned-Aerial-Vehicle

Design and Hover Test of Low Vibration Mach Scale Rotor with Twisted Composite Tailored Blade

Towards Virtual Testing of Flapping Flight

Laser Dynamic Testing System of Helicopter Rotor Blade Flap and Lag Angles

An Optoelectronic System For The In-Flight Measurement Of Helicopter Rotor Blades Motions And Strains

Flight Test System for Measuring the Aerodynamic Parameters of Rotor Blades

Transverse vibration of the blade for unmanned micro helicopter using Rayleigh-Ritz method

Test Verification for Improved Design of Rotor Blade by ESPI

High‐resolution Method for Measuring the Torsional Deformation of a Dragonfly Wing by Combining a Displacement Probe with an Acousto‐optic Deflector

Statistical modeling angular dynamics for model-scale helicopter.

Laser and vision-based measurements of helicopter blade angles

Dynamic Modeling of Helicopter Rotor Blades

Measurements Of Angle Of Attack For A Sub-100mg Insect -Inspired Micro Aerial Vehicle

A Study on Influence of Flapping Dynamic Characteristics on Vibration Control of Active Rotor with Trailing-Edge Flaps

Experimental and numerical investigation of the structural dynamic characteristics for both surfaces of a wind turbine blade

Measurement of Flapping-parameters and Calibration of Position-parameters for Standard Rotor Blade

Helicopter main rotor angular velocity analysis by laser Doppler velocimetry: simulation and experimental results

Measurement of the Flapping Angle and Torsional Angle of a Dragonfly Wing Using Fringe Projection Method

Monitoring the Dynamics of a Helicopter Main Rotor With High-Speed Stereophotogrammetry