Abstract:Micro-Doppler time–frequency analysis has been regarded as an important parameter extraction method for conical micro-motion objects. However, the micro-Doppler effect caused by micro-motion can modulate the frequency of lidar echo, leading to coupling between structure and micro-motion parameters. Therefore, it is difficult to extract parameters for micro-motion cones. We propose a new method for parameter extraction by combining the range profile of a micro-motion cone and the micro-Doppler time–frequency spectrum. This method can effectively decouple and accurately extract the structure and the micro-motion parameters of cones. Compared with traditional time–frequency analysis methods, the accuracy of parameter extraction is higher, and the information is richer. Firstly, the range profile of the micro-motion cone was obtained by using an FMCW (Frequency Modulated Continuous Wave) lidar based on simulation. Secondly, quantitative analysis was conducted on the edge features of the range profile and the micro-Doppler time–frequency spectrum. Finally, the parameters of the micro-motion cone were extracted based on the proposed decoupling parameter extraction method. The results show that our method can effectively extract the cone height, the base radius, the precession angle, the spin frequency, and the gravity center height within the range of a lidar LOS (line of sight) angle from 20° to 65°. The average absolute percentage error can reach below 10%. The method proposed in this paper not only enriches the detection information regarding micro-motion cones, but also improves the accuracy of parameter extraction and establishes a foundation for classification and recognition. It provides a new technical approach for laser micro-Doppler detection in accurate recognition.

Simulation and parameter extraction of flying‐bird motion echo based on laser micro‐Doppler effect

Research on Target Echo Characteristics and Ranging Accuracy for Laser Radar

Aerial Target Recognition with Enhanced Micro-Doppler Dynamic Features Based on Frequency-Modulated Continuous-Wave Radar

Geometric modeling and scattering characteristics analysis of multi‐degree‐of‐freedom flying targets

Measurement and Analysis of Radar Signals Modulated by Flapping Wings of Birds

A simulation method of aircraft dynamic RCS

Micro-Doppler feature analysis and extraction of the complex motion target

Avian Radar Detection Experiment Based on Analysis of Bird Targets' Scattering Characteristics

Decoupling and Parameter Extraction Methods for Conical Micro-Motion Object Based on FMCW Lidar

An estimation method of Unmanned Aerial Vehicle rotor spin frequency based on laser micro-Doppler effect

Aircraft Rotating Blades Radar Echo Model and Jem Feature Extraction

Using Radar Signatures to Classify Bird Flight Modes Between Flapping and Gliding

Research on Laser Detection Method of Rotor Chord Based on Micro-Doppler Effect

Precise Recognition of Warhead and Decoy Based on Components of Micro-Doppler Frequency Curves

Birds' Flap Frequency Measure Based On Automatic Detection And Tracking In Captured Videos

Identification and Analysis of Micro-Doppler Signature of a Bird Versus Micro-UAV

Modeling of micro-Doppler signatures from rotor blades

Research on Ground Object Echo Simulation of Avian Lidar

Optimized Radar Waveform Parameter Design for Small Drone Detection Based on Echo Modeling and Experimental Analysis

Multi-pulse laser radar target signal simulation based on target echo waveform model

Vibration-parameters Estimation Method for Airplane Wings Based on Microwave-photonics Ultrahigh-resolution Radar