Abstract:HCCI combustion was studied in a 4-stroke gasoline engine with a direct injection system. The electronically controlled two-stage gasoline injection and spark ignition system were adopted to control the mixture formation, ignition timing and combustion rate in HCCI engine. The engine could be operated in HCCI combustion mode in a range of load from 1 to 5 bar IMEP and operated in SI combustion mode up to load of 8 bar IMEP. The HCCI combustion characteristics were investigated under different A/F ratios, engine speeds, starts of injection, as well as spark ignition enabled or not. The test results reveal the HCCI combustion features as a high-pressure gradient after ignition and has advantages in high thermal efficiency and low NOx emissions over SI combustion. At the part load of 1400rpm and IMEP of 3.5bar, ISFC in HCCI mode is 25% lower and NOx emissions is 95% lower than that in SI mode. By introducing the second fuel injection in compression stroke, the stratified concentration is formed and the mixture is cooled, which means that HCCI ignition timing can be controlled and the load range can be extended by tuning mixture concentration and temperature. At critical ignition temperature, especially in SI/HCCI combustion mode transition, assisted spark ignition improves the stability of HCCI combustion. To better understand the physicochemical process within the cylinder, direct photographs on an optical engine using CCD camera had been used to analysis the intake, two-stage spray, compression and combustion process of the HCCI engine. The captured photographs show homogeneous lean charge could be realized by single fuel injection in intake stroke. Due to the intake swirl and squish flow during the compression stroke, the rich mixture formed by 2nd fuel spray are located near the spark. A great amount of spots are ignited simultaneously in fuel-rich zone, then it worked as an initiation to ignite the surrounding lean mixture zone. In this combustion system, a high intake swirl can be kept in the toroidal combustion chamber promoting fuel dispersion to reduce NOx emissions. Copyright © 2005 SAE International.

Optimizing Charge Stratification in a Lean-Burn Spark Ignition Engine

Two-Stage Lean-Burn Combustion Inside a Natural-Gas Spark-Ignition Engine with a Bowl-in-Piston Chamber

A Study on the In-Port Twice Fuel Injection Mode in a 5-Valve S.I.Engine

Lean Combustion and EGR Spark with Charge Stratification in an Ignition Engine

Local Charge Stratification In Spark-Ignition Engines

Lean combustion and EGR with charge stratification in a spark ignition engine

Local Mixture Injection to Extend the Lean Limit of Spark-Ignition Engines

A comparative analysis of the performances of a syngas port injection plus gasoline direct injection combined-injection spark-ignition engine under lean-homogeneous charge and Lean-Stratified Charge modes

Injection Strategy Optimization for a Multiple Premixed Compression Ignition Engine Based on Taguchi Method

Extending ultra-lean burn performance of high compression ratio pre-chamber jet ignition engines based on injection strategy and optimized structure

In-Cylinder Mixture Distribution Research of Stratified Lean-Burn Strategy and Stratified Stoichiometric Strategy in a GDI Engine Using Laser-Induced Fluorescence

Improving the lean burn performance of a high compression ratio methanol engine by multiple-injection

Effects of spark ignition and stratified charge on gasoline HCCI combustion with direct injection

Distributed Gas Ignition Using Injection Strategy for High Efficiency and Clean Combustion under Lean Condition

Trade-off on fuel economy, knock, and combustion stability for a stratified flame-ignited gasoline engine

Investigation of Two-Stage Split-Injection Strategies for a Dieseline Fuelled PPCI Engine

Experimental Research on Knocking Suppression Using Stratified Stoichiometric Mixture in a GDI Engine

Studies of Multi-Channel Spark Ignition of Lean N-Pentane/air Mixtures in a Spherical Chamber

Numerical investigation of the effect of fuel concentration stratification on gasoline compression ignition combustion under low-to-medium load conditions

Experimental Investigation about the Effect of Double-Spark Plug Ignition on Combustion Characteristics for Motorcycle Gasoline Engines with a Mild Lean Mixture

Evaluating the potential of mixture formation methods to achieve efficient combustion and near-zero emissions on a hydrogen direct injection engine