Abstract:The most common defect found in the high pressure die casting(HPDC) process is gas porosity which significantly affects the mechanical properties of the final components.As it is known,the air entrapment of the liquid metal flow during the mold filling stage has a close relationship with the gas porosity distribution in die castings.The generation of the entrapped air is mainly due to the interaction between air and liquid metal in the die cavity.In the past few decades,extensive efforts have been made to develop numerical models for the simulation of mold filling.However,these efforts mainly focused on the single phase flow models which can only predict the liquid metal flow and assume that the effect of air in the die cavity is negligible.As a result, these models could not provide the quantity and location of entrapped air in die castings.Recently, several research results on tracking the entrapped air in the molten metal flow have been reported but some techniques still need to be improved further and much more researches are required.In this study,a liquid-gas coupled model is presented to simulate the air entrapment phenomenon during the HPDC mold filling process.The pressure of the entrapped air bubbles is solved at each time step. The calculations of the liquid and gas phases are combined together through the pressure transfer.In order to verify the validity and stability of this model,a specially designed water analog experiment was carried out and compared with the numerical simulation results of the liquid-gas coupled model and the single phase flow model,respectively.The comparison shows that the liquid-gas coupled model has better prediction accuracy than the single phase flow model in tracking the entrapped air bubbles.

Numerical Simulation of Mold Filling and Water Analog Verification

Numerical simulation of mold filling of casting with an improved SOLA-VOF method

Numerical Simulation of Fluid Flow and Heat Transfer During Mold Filling for Die Casting

Simulation and Experimental Analysis on Non-circular Cross-section Parts Residual Wall Thickness of Water-assisted Injection Molding

Numerical simulation of water entry using CIP model

Numerical simulation of filling flow of polymer melt in injection molding

Study on Numerical Simulation of Mold Filling and Heat Transfer in Die Casting Process

Study and Application of Mold Filling Simulation of Shaped Castings

Numerical Simulation of Die-Casting Mold Filling Process Based on Fractional Step Method

An Improved Mathematical Model to Simulate Mold Filling Process in High Pressure Die Casting Using CLSVOF Method and CSF Model

Numerical simulation and experimental verification of the initial temperature distribution of castings during mold filling process

Modelling and Simulation for Die Casting Mould Filling Process Using Cartesian Cut Cell Approach

Study on numerical simulation of mold-filling and solidification processes of shaped casting

An Improved CIP-based Numerical Model for Simulating Free-Surface Flow with Adaptive Mesh

Water Analogue Experimental Study on the Filling Process of A Steam Turbine Housing Casting

3D Simulation of Filling Stage of Plastic Injection Molding Based on Improved Finite Volume Method

Water Analogue Validation of Numerical Model for Fluid Flow During Slow Shot Phase in Die Casting Process

Study on a Varied Grid Numerical Simulation of Mold Filling and Solidification in Casting Process

Development of a hybrid method for improved accuracy of mould filling computational models for castings

Numerical Simulation of Air Entrapment Phenomenon During Mold Filling of High Pressure Die Casting Process

Progress on Numerical Simulation of Mold Filling and Solidification Processes of Shaped Castings