Abstract:A new strategy has been developed to combine the nanotwins and dual‐scale particles into copper matrix composites and the comprehensive properties of Cu‐1Cr‐0.3Zr‐1ZrB2 exhibit excellently with the addition of intermediate aging and cryorolling. The effects of different deformation processes on the evolution of microstructure, room‐temperature and elevated‐temperature mechanical properties are investigated. The result demonstrates that the number of nano‐scale Cr precipitates increases obviously after intermediate aging. The nano‐sized Cr precipitates impede the movement of grain boundaries and dislocations, resulting in the refinement of deformation bands and the dislocation tangle. The combined effect of intermediate aging and cryorolling also improves the formation of nanotwins, which plays an important role in enhancing the tensile strength of composites. The tensile strength, elongation and conductivities of the composites subjected to two‐step cryorolling reaches 653 MPa, 8.02% and 79.51% IACS, respectively, showing an optimum comprehensive property. In addition, the stable nanotwins and the uniform distribution of dual‐scale particles inhibit recrystallization process at elevated temperature, contributing to improving the mechanical behavior at elevated temperature and heat‐resistant performance of composites. This article is protected by copyright. All rights reserved.

Structures, Properties and Responses to Heat Treatment of Deformation Processed Cu-15% Cr Composite Powders Prepared by Mechanical Milling

Achieving Homogeneous Fe Distribution and High Strength in Cu-Fe Composite Consolidated by Powder Rolling

Managing Mechanical and Electrical Properties of Nanostructured Cu-Fe Composite by Aging Treatment

Deformation Processed Cu-15 Wt Pct Cr Composite Synthesized by Hot Hydrostatic Extrusion of Mechanical Milled Powders

Densification of Cu-15wt%Cr composite powders prepared by mechanical milling

Mechanical milling and its influence on microstructure and electric conductivity of high mass fraction TiC / Cu composites

Effects of Process Parameters on Microstructure and Properties of TiC Reinforced Cu-Matrix Composites

Microstructures of 3%C-Cu Composite Powders Prepared by Mechanical Milling

Effects of Deformation on Microstructures and Properties of Submicron Crystalline Cu-5%Cr Alloy

Phases Interface in Deformation Processed Cu–15 Wt.%cr Composite Prepared by Elemental Powders

Effect of Heat Treatment on Mechanical Properties of CuCrZr Triply Periodic Minimal Surface Structures Fabricated by Selective Laser Melting

Improving the High Temperature Mechanical Performance of Cu-Cr Composite Induced by Residual Nano-Sized Cr Precipitates

Structural and thermal properties of the Fe-based alloys prepared by mechanical milling

Microstructure and Properties of Mechanically Milled AZ61 Powders Dispersed with Submicron/nanometer Ti Particulates

Structure and properties of the mechanically alloyed Cu-5Cr alloy

Characteristic Investigation of Trilayered Cu/Al8011/Al1060 Composite: Interface Morphology, Microstructure, and In-Situ Tensile Deformation

Distinct Electrical and Mechanical Responses of a Cu-10Fe Composite Prepared by Hot-Pressed Sintering and Post Treatment

Microstructural evolution and mechanical property of Cu‐Cr‐Zr‐ZrB2 composites subjected to cryorolling and aging treatment

Preparation and Crystallization Behavior of Cu-Zr-Ti Amorphous Composite Powders

Microstructure and properties of Mo-50%Cu alloy by mechanical milling and pressure-assisted solid state sintering

Microstructure evolution and property strengthening of CuCr50 prepared by thermite reduction-electromagnetic casting during the heat treatment process