Abstract:The tribological performance of copper-based powder metallurgical material is much influenced by the interfacial bonding between the components and matrix. By adding Cu-coated or uncoated graphite particles as a lubricant, two types of copper-based powder metallurgical materials were prepared via spark plasma sintering (SPS). The hardness, relative density, and thermal conductivity of the two specimens were firstly measured. Using an inertial braking test bench and temperature measuring instrument, the average friction coefficients, instantaneous friction coefficients, and friction temperatures of the two specimens were tested under different test conditions, and the wear rates were calculated accordingly. Based on the analysis of surface morphologies and elements distribution after the tests, the mechanisms of wear and formation of friction films were discussed. The results show that with the lubricant of Cu-coated graphite, the hardness, relative density, thermal conductivity, and interfacial bonding between the graphite and matrix can be greatly improved. Under the same test condition, the average friction coefficient, wear rate, and friction temperature of the specimen with added Cu-coated graphite are both lower than those of the specimen with added uncoated graphite. The two specimens show different variation trends in the instantaneous friction coefficient during the tests, and the variation of the instantaneous friction coefficient at a high initial test speed is also different from that at a low initial test speed for each specimen. The two specimens also show differences in the continuity of friction film and the content of graphite and oxide in the friction film.

Study on the Bond Strength between Cu-based Ceramet Friction Material and Steel Backing

Influence of Steel Fiber on Mechanic and Tribological Properties of Cu-Based Cermet Friction Material

Effect of Components on Mechanical Properties of Fe-matrix Bonding Diamond Tool

Research On Wear Behavior Of Atc Cermet Material

Optimisation of sintering parameters for bonding nanocrystalline cemented tungsten carbide powder and solid high strength steel

The Microstructure and Wear Characteristics of Cu–Fe Matrix Friction Material with Addition of SiC

Mechanical and tribological properties of FeS/Cu–Bi self-lubricating materials reinforced with copper-plated steel fibers

Study on the Tribological Performance of Copper-Based Powder Metallurgical Friction Materials with Cu-Coated or Uncoated Graphite Particles as Lubricants

SEM and SEAM study on tribological performance of cermets coatings

Synthesis and characterization of extremely hard and strong (W,Ti,Ta)C cermet by spark plasma sintering

Microstructure and Mechanical Properties of Sintered and Forged Fe-2Cu-0.5C-0.11S Materials

Investigating the effect of WC reinforcements in Cu Ti composite filler on the microstructural evolution and mechanical characteristics in brazing C f /SiC and GH3536

Study on the worn surface layers of the friction pair consisting of semimetallic friction materials and grey cast iron

Effect of Solid Fraction on Steel-Mushy Cu-Graphite Pressing Bonding

Testing and Analysis of Frictional Performance of Carbon Fiber/Metal Composite Materials

Friction and wear behavior of Ti(C,N) self-lubricating cermet materials with multilayer core-shell microstructure

Influence of Braking Conditions on Tribological Performance of Copper-Based Powder Metallurgical Braking Material

Tribological performance and composition optimization of semi-metallic friction materials applied for carbon ceramic brake disc

Impact Fracture Behaviour of Powder Metallurgy Steels Sintered at Different Temperatures

The structural effect of SiC form ceramic on the compressive strength and thermal expansion properties of Cu–SiC composites

Comparative study of metal-ceramic bonding strength by selective laser melting(SLM) and traditonal casting technology