Abstract:Analytical pyrolysis was conducted to study a relative comparison of the hydrocarbon and greenhouse gas emissions of three foundry sand binders as follows: (a) conventional phenolic urethane resin, (b) biodiesel phenolic urethane resin, and (c) collagen-based binder. These binders are used in the metal casting industry for making cores that are used to create internal cavities within castings. In this study, the core samples were flash pyrolyzed in a Curie-point pyrolyzer at 920 degrees C with a heating rate of about 3000 degrees C/sec. This simulated some key features of the fast heating conditions that the core binders would experience at the metal-core interface when molten metal is poured into green sand molds. The core samples were also pyrolyzed in a thermogravimetric analyzer (TGA) from ambient temperature to 1000 degrees C with a heating rate of 30 degrees C/min, and this simulated key features of the slow heating conditions that the core binders would experience at distances that are further away from the metal-core interface during casting cooling. Hydrocarbon emissions from flash pyrolysis were analyzed with a gas chromatography-flame ionization detector, while hydrocarbon and greenhouse gas (CO and CO2) emissions from TGA pyrolysis were monitored with mass spectrometry. The prominent hazardous air pollutant emissions during pyrolysis of the three binders were phenol, cresols, benzene, and toluene for the conventional phenolic urethane resin and biodiesel resin, and they were benzene and toluene for the collagen-based binder. It was also found that volatile organic compound and polycyclic aromatic hydrocarbon emissions considerably decreased in order from conventional phenolic urethane resin to biodiesel resin to collagen-based binder. These results have shown some similarity with those for stack emission testing conducted at demonstration scale and/or full-scale foundries, and the similar trends in the two sets of results offered promise that bench-scale analytical pyrolysis techniques could be a useful screening tool for the foundries to compare the relative emissions of alternative core binders and to choose proper materials in order to comply with air-emission regulations.

Clean Process of Animal Protein Glue Mold and Core Sand Foundry.

Research on Green Casting Technology and Equipment of Digital Frozen Sand Mold

Research on forming method of additive manufacturing of frozen sand mold

Technology and mechanism of a new protein-based core sand for aluminum casting

Rapid recycling of waste salt core materials in foundry industry using fractional crystallization

Relationship Between Mold's Hot-Pressing Strength and Steel Castings'Hot Tears by No-bake Furan Resin Sand Process

Fabrication and posttreatment for inorganic binder jetting sand molds for casting

Research on New Modified Phosphate Inorganic Resin Binder for Foundry

Regeneration of used sand with sodium silicate binder by wet method and their core manufacturing

The Status Quo and Prospect of Environmental Friendly Inorganic Binder for Foundry Use

Advanced oxidation to reduce emissions in foundries from coal pyrolysis

[Application of Analytical Pyrolysis in Air Pollution Control for Green Sand Casting Industry].

A Key Alternative for Reducing Harmful Emissions in Molding and Core-Making Technologies

Complete physico-chemical characterisation of foundry waste

Research, application and development of inorganic binder for casting process

Characterization of hydrocarbon emissions from green sand foundry core binders by analytical pyrolysis

Effects of Advanced Oxidation on Green Sand Properties Via Iron Casting into Green Sand Molds.

Environmental Toxicity of Waste Foundry Sand

Wettability, adhesive performance and structural evolution of an environment-friendly modified silicate binder for foundry moulding and coremaking

Study On Properties And Effects Of A New Heat Cured Inorganic Foundry Binder

A Novel and Clean Utilization of Multiple Solid Wastes to Produce Foam Glass-Ceramic