Abstract:Water-soluble cores are an effective solution for complex inner cavity castings due to its excellent ability of leaching out in water. Compared with the rapid development of 3D printing sand mold/core, the water-soluble core additive manufacturing technology is limited by its material properties because water-soluble inorganic salt materials tend to agglomerate and are transparent for the visible and near-infrared lasers. In this study, a process based on direct jetting potassium carbonate solution onto powder bed mix with ceramic sand and bentonite followed with post-treatment was proposed to prepare the water-soluble sand core. The mechanical property of the core was detected in different stages of the forming process, and the mechanism of strength and collapse was analyzed with the aid of phase diagram and scanning electron microscopy. The results show that the strength of binder jetting core exceeds 2 MPa after sintering at 900 °C for 10 min via pre-sintering and soaking, and the residual strength of the core decreases to 0.12 MPa, which guarantees the leachability of the core out of a casting under a slight vibration. Liquid bridge between sand grains built up in the process of binder jetting transforms into K 2 CO 3 bonding bridge during the heating process, and a reticular structure of KAlSi m O n grows up with the increase of sintering temperature and the extension of time, which explains the pre-sintered core maintains the original shape in K 2 CO 3 solution and the sintered core has a low strength after soaking in water. What is more, a casting trial of tee pipe was conducted to verify the suitability of the developed cores for aluminum alloy castings with complex internal cavities.

Technology and mechanism of a new protein-based core sand for aluminum casting

A New Phosphate Binder for Making Sand Mold or Core for Aluminum Alloy Castings

Core-Shell Bioactive Ceramic Robocasting: Tuning Component Distribution Beneficial for Highly Efficient Alveolar Bone Regeneration and Repair.

Cost-effective Fabrication of Bio-Inspired Nacre-Like Composite Materials with High Strength and Toughness

Water-Soluble Sand Core Made by Binder Jetting Printing with the Binder of Potassium Carbonate Solution

Research on New Al-Mg-B Compound Phosphate Inorganic Binder for Heat Cured Sand

Fabrication and posttreatment for inorganic binder jetting sand molds for casting

Research on frozen sand mold casting technology for complex thin-walled aluminum alloy castings

Alumina-Based Ceramic Core Nano-Composites For Investment Casting

3D Printed (Binder Jetting) Furan Molding and Core Sands—Thermal Deformation, Mechanical and Technological Properties

Superiority of a New Modified Phosphate Casting Binder

Study and Application on No Bake Phosphate High Chromite-Corundum Sand

Controlled Cooling of an Aluminum Alloy Casting Based on 3D Printed Rib Reinforced Shell Mold

Fabrication of carbon fiber reinforced aluminum matrix composites by inorganic binders

Clean Process of Animal Protein Glue Mold and Core Sand Foundry.

Performance of a Water-Soluble Ceramic Core and Its Application in Aluminum Casting

Research on forming method of additive manufacturing of frozen sand mold

Cooling Control for Castings by Adopting Skeletal Sand Mold Design

Research, application and development of inorganic binder for casting process

Study of Environmentally Friendly Phosphate-Bonded No-Bake Sand

Alumina-based ceramic mold with integral core and shell for hollow turbine blades fabricated by Laser powder bed fusion