Abstract:In our previous work, a new technology has been proposed that the cooled synthetic gas (syngas) produced in the partial oxidation process can be used as quenching medium. The mixing of the hot product gas and cold syngas is critical to this new quenching approach. In this work, both experimental measurements and CFD simulations were conducted to study the mixing behavior of the jets in cross-flow (JICF). A mixing apparatus with four jets was set up. Methane was used as the tracing gas and the concentration distribution was measured using an FID detector. The realizable k-epsilon model was found to give better predictions of the experimental data among the three k-epsilon models. The effects of jet incident angle theta, jet velocity to mainstream velocity ratio VR and Reynolds number on the mixing behavior were investigated. The results showed that the optimum jet incident angle was 145 degrees. For configuration with jet incident angle smaller than 130 degrees, increasing the velocity ratio VR in the range of 1-3 improves the mixing. When the jet incident angle is larger than 130 degrees, the optimized range of velocity ratio VR is 1.8-2.4. The Reynolds number has insignificant effect on the spatial distribution of mixedness, indicating that the optimum design parameters obtained at low Reynolds number can be used to guide the choosing of industry operating conditions with Reynolds number as high as 3.13x10(5)-6.26 x 10(5).

Study on Jet Mixing Characters in the Oxidation Reactor for Titanium Dioxide Powder Production by Chloride Process

Gas Cross-Flow Mixing in TiO2 Oxidation Reactor of Chloride Process

Technology Progress of P-Xylene Oxidation Reactor

Influence of mixing inside microreactor on microstructural evolution of Cu-ZnO catalyst

The Effect of Mixing on Co‐precipitation and Evolution of Microstructure of Cu‐ZnO Catalyst

Micro-Mixing Enhancement in a Taylor-Couette Reactor Using the Inner Rotors with Various Surface Configurations

Sacling Mechanism on the Oxidation Reactor Wall in TiO2 Synthesis with Chloride Process

Mixing Behaviors of Jets in Cross-Flow for Heat Recovery of Partial Oxidation Process

Effect of Hydrodynamic Heterogeneity on Micromixing Intensification in a Taylor–Couette Flow Reactor with Variable Configurations of Inner Cylinder

Controlled synthesis of nano-sized TiO_2 powders using high-temperature vapor phase process

Experimental Study about Mixing Characteristic and Enhancement of T-jet Reactor

Evaluation of Mixing Performance for the Industrial-Scale Radial Multiple Jets-in-crossflow Mixing Structure

Morphological Structure of Nanometer TiO2–Al2O3 Composite Powders Synthesized in High Temperature Gas Phase Reactor

Oxidation behavior of low-cost CP-Ti powders for additive manufacturing via fluidization

Mixing effects of high-speed jets in gas-solid riser and downer reactors

Bubble Evolution and Gas-Liquid Mixing Mechanism in a Static-Mixer-based Plug-Flow Reactor: A Numerical Analysis

Composition of off-gas produced by combined fluidized bed chlorination for preparation of TiCl4

Preparation of Nanometer Rutile TiO2 Particles by High Temperature Gas Phase Reaction

Mixing in the Confined Vortical Flow in Non-Aligned T-jets Reactors

Morphology and Photocatalytic Activities of Ultrafine TiO2 Particles Synthesized in High Temperature Aerosol Reactor

The effects of aluminum as dopant on the characteristics of titania uitrafine particles produced by gas-phase oxidation