Abstract:Functional Materials Letters, Ahead of Print. BaTiO3/Nb:SrTiO3 thin film oxides have been deposited on SrTiO3 substrates using a pulsed laser deposition system. Different annealing methods were thereafter used to assess the ferroelectricity of the grown films. The residual polarization value, 2Pr, of 4.205 [math]C/cm2 and saturated residual polarization value, 2Pmax, of 15.484 [math]C/cm2 were obtained using in-situ annealing. After performing rapid thermal annealing (RTA) annealing, the residual polarization value rose to 4.676 [math]C/cm2 and the saturated residual polarization value rose to 18.723 [math]C/cm2. Furthermore, a comparison of results showed that the saturation test frequency of the in-situ annealing was 10 times higher than the saturation test frequency of the RTA. This could be explained by the fact that the secondary high-temperature annealing led to a decrease in the conductivity of the doped oxide and, thereby, a decrease in the effective electric field that was applied to both ends of the BTO (BaTiO3) film. Thus, a lower frequency was required to ensure a flip of all ferroelectric domains within the BTO film. By testing the fatigue frequency at 100 kHz, 10[math] stable cycles in both annealing methods and the results confirmed the good stability of the device performance. A linear fit analysis of the [math]–[math] curves showed under in-situ annealing the presence of both a bulk-limited current mechanism that was dominated by the space charge limited current (SCLC) and Pool–Frenkel (PF) mechanisms, and an interface-limited current that was dominated by the Fowler–Nordheim (FN) mechanism in the structure. After RTA annealing, the conducting mechanism is ohmic contact at low electric field and the SCLC mechanism at high field strength. The results show that after RTA annealing, the quality and ferroelectric properties of the films are significantly improved compared to those under in-situ annealing. These results showed that the BTO/NSTO/STO (BaTiO3/Nb:SrTiO3/SrTiO3) structure had a standard test frequency as well as reliable stability. The BTO/NSTO/STO structure showed, therefore, promising applications in future nonvolatile information memory devices.

In Situ Electrical-Field-induced Growth and Properties of Bi3TiNbO9 Ferroelectric Thin Films

Direct observation of room-temperature out-of-plane ferroelectricity and tunneling electroresistance at the two-dimensional limit

Effect of In-Situ Applied Electric Field on Structure and Ferroelectric Properties of SrBi 2 Ta 2 O 9 Films

Characteristics of SrBi2Ta2O9 ferroelectric films in an in situ applied low electric field prepared by metalorganic decomposition

Bismuth-Layered-Ferroelectric Bi3tinbo9 Thin Films Grown by Pulsed Laser Deposition

Ferroelectric properties and current mechanisms of BaTiO[math]/Nb:SrTiO[math] thin films

Direct observations of electric-field-induced domain switching and phase transition in 0.95Na<sub>0.5</sub>Bi<sub>0.5</sub>TiO<sub>3</sub>-0.05BaTiO<sub>3</sub > single crystals using in situ transmission electron microscopy

Electrical Properties of Chemical-Solution-derived Bi3.54Nd0.46Ti3O12 Ferroelectric Thin Films

Ferroelectric properties of Bi3.25-x/3La0.75Ti 3-xNbxO12 films prepared by pulsed laser deposition

Direct observations of electric-field-induced domain switching and phase transition in 0.95Na 0.5 Bi 0.5 TiO 3 -0.05BaTiO 3 single crystals using in situ transmission electron microscopy

Giant electric field-induced strain and structure evolution of NaTaO3-modified 0.94(Bi0.5Na0.5)TiO3-0.06BaTiO3 Pb-free ceramics

Pulsed laser deposition and characteristics of SrBi2 TaNbO9 thin films

Pulsed laser deposition and characteristics of SrBi2TaNbO9 thin films

Microstructure And Ferroelectric Properties Of Sol-Gel Derived Bi3.15nd0.85ti3o12 Thin Films On Pt/Ti/Sio2/Si(100)

Enhancement of Piezoelectricity in Spin-Coated Bi1/2Na1/2TiO3-BaTiO3 Epitaxial Films by Strain-Engineering

Effect of in situ applied electric field on the growth of La2Ti2O7 thin films by chemical solution deposition

Polarization behavior of` lead-free 0.94(Bi0.5Na0.5)TiO3-0.06BaTiO3 thin films with enhanced ferroelectric properties

Effect of an in-situ applied electric field on growth of Bi4Ti3O12 films by sol–gel

Modulation of Phase Boundary and Domain Structures to Engineer Strain Properties in BNT-based Ferroelectrics

Preparation and ferroelectric properties of (124)-oriented SrBi4Ti4O15 ferroelectric thin film on (110)-oriented LaNiO3 electrode

Ultra-high strain responses in lead-free (Bi0.5Na0.5)TiO3-BaTiO3-NaNbO3 ferroelectric thin films