Abstract:During the bearing service, a series of microstructural evolutions will arise inside the material, such as the appearance of feature microstructures. The essential reason for the microstructural evolution is the cumulative effect of cyclic stress. The Hertz Contact formula is usually adopted to calculate the internal stress, and there is a correlation between the shape and distribution of the feature microstructure and the stress distribution. But it is insufficient to explain the relationship between the morphology of feature microstructures and the rolling direction, such as specific angles in butterfly and white etching bands. The rolling phenomenon will cause the asymmetry of stress distribution in the material, which is the source of the rolling friction coefficient. Moreover, slipping or microslip will produce additional stress components, which also cause the asymmetry of the stress field. However, there is no experimental or theoretical explanation for the relationship between the asymmetry of the stress field and the feature microstructure. According to the current theory, the appearance of feature microstructures is caused by stress with or without rolling. Therefore, it is of great significance to study the formation mechanism: whether feature microstructures will appear in the uniaxial cyclic compression stress field without rolling. In this paper, uniaxial cyclic compressive stress was loaded into a plate-ball system and a cylinder system. The characteristics of microstructural change of bearing steel (GCr15) were studied. It was found that the hardness of the material increased after the cyclic compressive load, and the inclusions interacted with the matrix material. In the local microregion a white etching area was found, although the scale is very small. No large-scale feature microstructures appeared. Other phenomena in the experiment are also described and analyzed. For example, the production of oil film in the contact area and the changing law of alternating load.

FAILURE ANALYSIS TO THE CRACKING IN THE AXLE SLEEVE OF GCr15 STEEL

Failure analysis for outer ring cracking of GCr15 rolling bearing

Failure Analysis on the Rear Axle Shaft of Automobile

Effects of heat treatment on fatigue properties of double vacuum smelting high‐carbon chromium bearing steel

Fracture Analysis of GCr15 Steel Cycloid Gear

Study on Decarburization Mechanism and Law of GCr15 Bearing Steel during Heat Treatment

Research on the failure mechanism of the high-speed train bearing steel under static load failure

Cracking in a Fe–25Mn–3Si–3Al Steel

Microstructure Characteristics of the Compound Layer Cracked During Grinding on QPQ‐Treated Cr‐Containing Steel Shafts

Failure Analysis on Vertical Cracking of Medium Carbon Bainitic Steel Backup Roll

Fracture Analysis on Gear Shaft in Vulcanizer Tire Foundation

Fracture failure analysis on Alloy783 bolts in medium-pressure valve bonnets of USC units

Failure analysis and improvement of a 42CrMo crankshaft for a heavy-duty truck

Fatigue Crack Initiation and Propagation at High Temperature of New-Generation Bearing Steel

Preliminary Research on Response of GCr15 Bearing Steel under Cyclic Compression

Establishment of Thermal Ductile Fracture Criterion for As-Cast 42CrMo Steel and Its Application in Hot Ring Rolling Process

Fracture Analysis of High Chromium Cast Iron Roll on CSP Mill

Atomic-Scale Insights into Damage Mechanisms of GGr15 Bearing Steel Under Cyclic Shear Fatigue

Effect of Carbides on Thermos-Plastic and Crack Initiation and Expansion of High-Carbon Chromium-Bearing Steel Castings

Analysis and control of surface cracks in a B-bearing continuous casting blooms

Fracture failure analysis of the teeth of conjunction gear made of 20MnCr5S steel