Abstract:A series of uni-axial tensile cycling tests were conducted at room temperature in superelastic NiTi strip specimens with nano-grain size. The NiTi superelastic strip specimen's Apparent Young's Modulus (AYM) and the critical stress decrease when the specimen is subjected to an external uni-axial stress and the strain being higher than 1.5%. Both of the AYM and the critical stress become steady after 10-time cycling. The number of the (111)[1 (4) over bar3] oriented grains increases with extending the strain value. The sub-grain size grows with increasing mechanical cycling number due to the annihilation of the small angle boundaries. The AYM-softening is related to the grain re-orientation (texture evolution) and the formation of irreversible-stabilized B19' martensitic variants. The softness of the critical stress is principally attributed to the aspect that the grains re-orient to align along the two textural components (111)[1 (1) over bar0] and (111)[1 (4) over bar3] when the external stress being applied. The rotation of grains towards the observed orientation gives higher Schmid factor for the transformation and is one of the reasons for the decrease in AYM and critical stress. The orientation relationships between B2 parent phase and the strain-induced B19' martensite are observed to be: [111](B2) // [10 (1) over bar](M), (1 (1) over bar0)(B2) // (010)(M) and [111](B2) // [(1) over bar 10](M) and (1 (1) over bar0)(B2) // (001)(M).

Stress-induced deformation at Ap～Mp and thermal cycling behavior of Cu-Al-Ni single crystals

Stress-induced Deformation at A_p～M_p and Thermal Cycling Behavior of Cu-Al-Ni Single Crystals

Stabilization of deformed stress-induced martensite and its effect on shape memory effect in an Fe-Mn-Si-Ni-Co alloy

Superelastic behavior and stabilization of stress-induced martensite in Cu-13.4Al-4.0Ni single crystals

Influence of Isothermal Treatment on Superelastic Behavior of Cu-13.8al-4.0ni(Mass Fraction) Single Crystals

Deformation Dependence of Transformation Behavior of Ti-Ni-Nb Wide Hysteresis Shape Memory Alloy

Degradation of the recoverable strain during stress controlled full transformation cycling in NiTi shape memory alloys

Transformation Pattern of Shape-Memory NiTi Alloy During Stress-Biased Thermal Cycling

A Study of the Internal Deformation Fields and the Related Microstructure Evolution during Thermal Fatigue Tests of a Single-Crystal Ni-Base Superalloy

Anomalous hot deformation behavior and microstructure evolution of as-cast martensitic NiTi alloy during hot compression

Abnormal superelastic cyclic behavior and stress-induced martensitic transformation mechanism of NiTi alloy with R phase

EXPERIMENTAL INVESTIGATION ON THE STRESS-INDUCED MARTENSITIC TRANSFORMATION AND THE MICROSTRUCTURE EVOLUTION IN CuAlNi SINGLE CRYSTAL

Relationship Between Colored Microstructure under Polarized Light and Shape Recovery Characteristics on the Thermomechanical Cycled CuAlNi Single Crystals

Effect of Cyclic Loading on Apparent Young's Modulus and Critical Stress in Nano-Subgrained Superelastic NiTi Shape Memory Alloys

DEFORMATION-INDUCED MARTENSITIC TRANSFORMATION AND ITS REVERSIBILITY IN Ni-Ti-Nb WIDE HYSTERESIS SHAPE MEMORY ALLOYS

The Precipitation Behaviors, Martensite Transformation and Superelasticity in the Aged Ni-rich TiNi Alloy with the Assist of Super-High Stress

Hot compression deformation behavior of Cu-2.32Ni-0.57Si-0.05P alloy

Effect of Deformation on the Stress-Induced Martensitic Transformation Behavior of Ti44ni47nb9 Wide Hysteresis Shape Memory Alloy

Microstructure, Martensitic Transformation And Superelasticity Of T1(49) (6)N1(45 1)Cu(5)Cr(0 3) Shape Memory Alloy

In-situ Synchrotron Diffraction Study of the Localized Phase Transformation and Deformation Behavior in NiTi SMA

Effects Of Parent Phase Aging And Thermal Cycling On Shape Memory Characteristics In A Cu-Zn-Al Alloy