Abstract:Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications, Ahead of Print. Shape memory alloys have made rapid progress in many domains, primarily biomedical (endovascular stents, orthodontic archwires), and engineering (smart actuators, robotics, hydraulic couplings). The selection of a shape memory alloy for the indented application is based on its characteristic phase transformation temperatures. These characteristic temperatures are influenced by myriad parameters, such as composition, microstructure of the alloy, defect density, etc. When an shape memory alloy under an external load is subjected to cyclic operations to perform useful work, for example, actuators, these characteristic temperatures are modified. This study, therefore, aims to understand the influence of external loading on the shape memory characteristics of a Ni50Ti45Cu5 (at.%) alloy. A wire of 1.43 mm diameter and length of 100 mm was subjected to heating and cooling between its phase transformation temperatures in a cyclic manner under constant stress (of up to 60 MPa). The maximum recovery strain, actuation/retraction rate, and the stress influence coefficient were determined and compared with those of the other Ni-Ti and Cu-based shape memory alloys. The results show that raising the load level causes an increase in the transition temperatures, especially the Ms (martensite start temperature) rather than the other phase transformation temperatures (martensite finish (Mf), austenite start (As), austenite finish (Af)). It also significantly affects the recovery strain and the rate of retraction during forward transformation and the symmetry of operation.

Effects Of Parent Phase Aging And Thermal Cycling On Shape Memory Characteristics In A Cu-Zn-Al Alloy

Stabilization of deformed stress-induced martensite and its effect on shape memory effect in an Fe-Mn-Si-Ni-Co alloy

Study on Aging Effect and Mechanism of Cu-11.1Al-6.5Mn-1.6Zn-0.1Zr Shape Memory Alloy

Thermal Cycling Effect In Cu-11.9al-2.5mn Shape Memory Alloy With High M-S Temperature

Influence of Heat Treatment on Microstructures and Shape Memory Effect of Cu-28Zn-2.5Al wt. % Produced by Gravity Casting

Failure mechanism of reverse shape memory effect in a Cu-base alloy

Transformation Behaviour with Thermal Cycling in Ti50Ni43Cu7 Shape Memory Alloy

The Effect of Annealing Temperature and Quenching Media Variations On Heat Treatment Process of Cu-Zn-Al Shape Memory Alloys For Shape Memory Effect and Microstructure

Temperature Memory Effect in CuAlNi Single Crystalline and CuZnAl Polycrystalline Shape Memory Alloys

The Effect of Ageing Treatment on Shape-Setting and Shape Memory Effect of a NiTi SMA Corrugated Structure

Effect of Aging on Martensitic Transformation and Superelasticity of TiNiCr Shape Memory Alloy

EFFECT OF MARTENSITE ORDERING ON SME IN A Cu-Zn-Al ALLOY

Effect of Al content on thermal stability, shape memory effect and mechanical properties of Cu–Al–Fe shape memory alloys

Effect of Aging on the Phase Transformation and Mechanical Behavior of Ti36ni49hf15 High Temperature Shape Memory Alloy

Microstructural features, martensitic transformation, and functional properties of multicomponent Ti–Ni based shape memory alloys

Effect of Pre Aging on the Transformation Temperatures of Cu-Al-Ni Single Crystals

Effect of aging treatment on evolution of S′ phase in rapid cold punched Al−Cu−Mg alloy

Effects of Quenching Media on Phase Transformation Characteristics and Hardness of Cu-Al-Ni-Co Shape Memory Alloys

Effect of heat treatment on shape memory properties of ductile CuAlMn alloys

Influence of applied stress on shape memory characteristics of Ni50Ti45Cu5 (at.%) alloy subjected to thermomechanical cycling

Effect of Cooling Rate on Microstructure, Shape Memory Effect and Mechanical Properties of Cu–13Al–5Fe High-Temperature Shape Memory Alloy Fabricated by Laser Powder Bed Fusion