Abstract:The two-dimensional finite element microscopic model of NiCoCrAlY/YSZ gradient thermal barrier coating was established by using the representative volume element method to calculate the thermophysical properties of the gradient layer under different composition ratios. The parameter results were extended to the three-dimensional multi-layer solid model to study the thermodynamic properties of the double-layer coating and gradient structured coating under thermal cycling condition. The results show that the elastic modulus, Poisson’s ratio, coefficient of thermal expansion and thermal conductivity of the gradient layer are approximately linear with the component proportion of each phase, and the thermal conductivity is also affected by the distribution pattern of each phase. The thermal conductivity is low and the highest value is 2.91 W·m -1 ·K -1 when the proportion of NiCoCrAlY phase in the gradient layer is below 0.7 at room temperature. Compared with the double-layer coating, the proportion of YSZ in gradient coatings is reduced by 20%, the insulation temperature is reduced by 14%, the radial tensile stress, axial tensile stress, and shear stress of the ceramic surface layer at high temperature are reduced respectively by 47%, 32% and 37%, and the residual stress after cooling is reduced by 50%. The results are attributed that the gradient of the coating structure can effectively reduce the thermal mismatch stress caused by the difference in the thermal expansion coefficient between coating and substrate. According to the results of coating stress distribution, the coating is inclined to form vertical cracks in the centre region and horizontal cracks near the outer edge of the TC/BC interface.

EFFECTS OF THE SUBSTRATE TEMPERATURE ON MI CROSTRUCTURE AND PROPERTY OF EB-PVD GRADI ENT THERMAL BARRIER COATINGS

Different Growth Mechanisms of Alumina on the Surface of NiPtAl and MCrAlY Bondcoatings in EB-PVD TBC System

The effect of temperature and roughness of the substrate surface on the microstructure and adhesion strength of EB-PVD ZrO2-%8wtY2O3 coating

Effects of a nano carbide coating fabricated by EB-PVD on the interfacial stability of aluminide coated superalloy

Sintering and Failure Behaviour of Eb-Pvd Thermal Barrier Coating after Isothermal Treatment

Effects of Heat Treatment on Structure Transformation of Cr/Al Composite Coatings

Preparing and Study of EB-PVD Thermal Barrier Coatings on Titanium Substrates

Thermal cycling of EB-PVD TBCs based on YSZ ceramic coat and diffusion aluminide bond coat

Effect of Heat Treatment at 900 °C on Microstructural and Mechanical Properties of Thermal Barrier Coatings

The effects of substrate temperature on the residual stress for EBPVD

Effect of sintering temperature on microstructure and properties of thermal barrier coating

Microstructure and Thermal Cycling Behavior of Thermal Barrier Coating on Near-Α Titanium Alloy

Influence of atomic migration mode at different temperatures on the microstructure, mechanical and cavitation erosion behaviors of Co-based alloy coating

Effect of substrate temperature on microstructure and residual stress of EB-PVD ZrO2 coating

Dependence of microstructure and thermal conductivity of EB-PVD thermal barrier coatings on the substrate rotation speed

Structural Optimization for the Thermal Conductivity and Thermal Cycling Behavior in Thermal Barrier Coatings and Analysis of Thermomechanical Properties by Computational Investigation

The Effects of Substrate Temperature on the Residual Stress for EBPVD TBCs

Finite Element Simulation of Thermodynamic Properties of NiCoCrAlY/YSZ Gradient Coating

Study of Failure of EB-PVD Thermal Barrier Coating Upon Near-Α Titanium Alloy

Microstructural Design and Thermal Cycling Performance of a Novel Layer-Gradient Nanostructured Sc2O3–Y2O3 Co-Stabilized ZrO2 Thermal Barrier Coating

The Influence of Temperature Gradient Across YSZ on Thermal Cyclic Lifetime of Plasma-Sprayed Thermal Barrier Coatings