Abstract:The micro-texture is a relatively well-established method for improving the tribological performance of Co-Cr-Mo alloy. Currently, to fabricate the micro-textures on the alloy surface, laser micromachining technology is the commonly used method. However, the low fabrication quality (such as irregular protrusions inside and on the edges of the micro-textures) caused by laser ablation limits the numerous application of laser surface textures. Therefore, a novel method of combining nanosecond (ns) pulse laser texturing with ion beam etching was proposed to prepare the micro-textures on the surface of Co-Cr-Mo alloy. The tribological properties before and after ion beam etching were tested by ball-disk friction wear test for three different micro-texture morphologies (grooved micro-texture (G); hexagonal micro-texture (H); concentric micro-texture (C)), and the micro-topography, mechanical properties and wettability of the ion beam/laser textured Co-Cr-Mo alloy were also investigated. The results showed that the friction coefficient and wear amount of the specimen surface were reduced after ion beam etching, and the ion beam/laser textured sample with hexagonal micro-textures showed the best wear performance, with the average friction coefficient reduced by 11.9 % and the wear amount of polyether ether ketone balls reduced by 14.9 %. The worn surface of the ion beam etched samples was relatively smooth, and the adhesive wear was also reduced. This report established the friction reduction model of ion beam/laser textured alloy and revealed the friction reduction mechanism of ion beam etching, providing a new idea of fabricating high-quality micro-textures to enhance the wear performance of artificial hip joints.

Tribological Properties of Ion-implanted Epoxy Resin

A Study of the Corrosion Resistance of M50NiL Bearing Steel by Ion Implantation

Effects of Titanium-Implanted Dose on the Tribological Properties of 316L Stainless Steel

Effect of Dose Rate on Tribological Properties of 8Cr4Mo4V Subjected to Plasma Immersion Ion Implantation

The microstructure and tribological properties of M50 steel surface after titanium ion implantation

Improved Mechanical Properties of Al2O3/PTFE Layer by Metal Ion Implantation

Study of Tribological Properties of High-Speed Steel Implanted by High-Dose Carbon Ions

Tribological Properties of Ion Implanted UHMWPE Against Si3N4 under Different Lubrication Conditions

Effects of Single- and Dual-Element Ion Implantation on Tribomechanical Properties of Cronidur 30 Bearing Steel

Coevaporation and Ion Implantation of Pd5Ti5 and Pt5Ti5 on AISI Stainless Steels for Reducing Wear and Friction

Nitrogen Ion Implantation on the Mechanical Properties of Aisi 420 Martensitic Stainless Steel

A Study on the Wettability of Ion-Implanted Stainless and Bearing Steels

Effect of ion beam etching on the tribological performance of laser textured Co-Cr-Mo alloy

High Temperature Sliding Wear Behaviors of Ion Plating Tin Composite Coating with Ion Nitriding As Interlayer on Hot Work Die Steel

Effects of Nitrogen Ion Implantation and Implantation Energy on Surface Properties and Adhesion Strength of TiN Films Deposited on Aluminum by Magnetron Sputtering

STUDY ON IMPROVING WEAR RESISTANCE OF EPOXY RESIN FILLED WITH NANOMETRIC ALUMINA

Hardness and Tribological Properties of Silicon Nitride Ceramics Implanted by Titanium Ions with MEVVA Sources

Microstructure and Mechanical Properties of Ti + N Ion Implanted Cronidur30 Steel.

Study on comparision of the mechanical properties of ceramics after ion implantation

Improvement of nitrogen ion implantation on the wear and corrosion resistance of bearing steel in NaCl solution

MECHANISM OF WEAR RESISTANCE ON ENERGETIC ION IMPLANTED POLYMER FILMS