Abstract:This paper proposes a bulk micromachined bandpass filter on 0.5mm-thick Pyrex glass, whose operation is based on the splitting of the odd and even degenerate mode in a dual-mode resonator, with the addition of a perturbation element. In such a way, a filter may require only half resonators of a traditional one, resulting in a more compact configuration over those ever reported. A 4%-bandwidth bandpass filter centered at 17GHz was designed. The square-ring-like coplanar waveguide (CPW) act as a dual-mode resonator, and an open-circuited stub attached to the inner corner of the square-ring acts as the perturbation element and dominates the filter bandwidth. The two bulk-micromachined switches for tuning are placed symmetrically along the diagonal line. Since the electrical length of CPW is extended after being loaded by capacitive switches, both the degenerate resonating frequencies and the filter mid-band frequency are shifted downward. Theoretical formulas are derived for various actuation states of all the switches. The filter performance is analysed also using finite-element fullwave tools. A frequency shift of 0.6GHz is seen which is close to 0.58GHz obtained from analytical solutions. Both the original and tuned state come with satisfying microwave performance, i.e. low passband insertion-loss (< 0.5dB) and return-loss (< −15dB) and high stopband rejection. It is also shown that the simulated result is in good agreement with theoretical solutions. The bulk microfabrication is shown to be much simpler than surface micromachining conventionally used for RF MEMS switches. Since the bridge skeleton is Si, thermal mismatch between all-metal bridge and dielectric substrate is avoided, and reliability at elevated temperature is guaranteed or at least greatly improved. Besides, the p++ doped Si line patterned simultaneously with the microbridges, can also be used as a DC biasing resistor, which can eliminate the additional steps to fabricate the resistive alloy line. The tested results of the fabricated switch samples are also shown. The device may be a good candidate for novel Ku-band inter-scientific satellite communication or wireless networking.

Study of BAW Filter Using Surface Micromachining

Surface Micromachining of Bulk Acoustic Wave Filters

Rf-Mems Baw Filter Using Surface Micromachining

A Novel Piezoelectric-Based RF BAW Filter

A Novel Surface-Mounted Monoblock Dielectric Filter

Bulk acoustic wave RF technology

Patterned Microstructure Array Fabrication By Using A Novel Standing Surface Acoustic Wave Device

Design of a RF Bulk Acoustic Wave Filter Using PZT Thin Film

A Bulk Micromachined Tunable Dual-Mode Microwave Bandpass Filter on Coplanar Waveguide

Realization Of An Integrated Planar Lc Low-Pass Filter With Modified Surface Micromachining Technology

A Modified Lattice Configuration Design for Compact Wideband Bulk Acoustic Wave Filter Applications

Compact Dual‐layer Substrate‐integrated Waveguide Bandpass Filters with Controllable Transmission Zeros

Structure With Thin Siox/Sinx Bilayer And Al Electrodes For High-Frequency, Large-Coupling, And Low-Cost Surface Acoustic Wave Devices

Materials, Devices Design and Applications of Thin Film Bulk Acoustic Wave Filters

Materials, Design, and Characteristics of Bulk Acoustic Wave Resonator: A Review

Radio Frequency Bulk Acoustic Wave Filters: Current Status and Future Prospective

Encapsulation of Film Bulk Acoustic Resonator Filters Using A Wafer-Level Microcap Array

Ultra-Wideband Surface Acoustic Wave Filters Based on the Cu/LiNbO 3 /sio 2 /sic Structure

Near 30% Fractional Bandwidth Surface Acoustic Wave Filters with Novel Electrode Configuration

Wideband and Low-Loss Surface Acoustic Wave Filter Based on 15° YX-LiNbO₃/SiO₂/Si Structure

Micromachined Thick Mesh Filters for Millimeter-Wave and Terahertz Applications