Abstract:In this work, the effect of the addition of different amounts of TiO 2 nanotubes to a PtRu catalyst supported on Vulcan XC-72R carbon black for methanol oxidation was studied. Two approaches were used for the catalyst preparation. In the first case, Pt and Ru metal ions were impregnated onto the support (C-TiO 2 ) and subsequently reduced with NaBH 4 . In the second case, the metal ions were first reduced and then impregnated, in order to obtain a catalyst with metal loading of 30 % of PtRu (50:50 at.% composition of Pt/Ru) and varying concentrations of TiO 2 (5–15 wt%); the actual composition was determined by inductively coupled plasma optical emission spectrometry (ICP-OES) analysis. The electrochemical properties were studied via cyclic voltammetry and chronoamperometry in 0.5 M H 2 SO 4 solution. X-ray diffraction analyses indicated the formation of PtRu alloy with different degrees of alloying. The CO-stripping voltammetry studies showed that both the onset potential and the peak potential are dependent on the catalyst composition; the PtRu/C-TiO 2 (10) exhibited a relatively higher CO oxidation current compared to those exhibited by the other catalysts. Both the linear sweep voltammetry and the chronoamperometric results also demonstrated that the PtRu/C-TiO 2 (10) catalyst exhibited a higher methanol oxidation current and a lower poisoning rate among the investigated catalysts with various TiO 2 nanotube contents (i.e., 0, 5, and 15 % TiO 2 ). The prepared catalysts revealed essentially the same catalytic performance independently of the procedure used for their preparation.

Effect of Titanium on Methanol Synthesis from CO2 Hydrogenation over Cu/γ-Al2O3

Effect Of Titanium On Methanol Synthesis From Co2 Hydrogenation Over Cu/Gamma-Al2o3

CO2 Methanation over TiO2–Al2O3 Binary Oxides Supported Ru Catalysts

RKCL3827 METHANOL SYNTHESIS BY CO2 HYDROGENATION OVER TITANIUM MODIFIED Γ-Al2o3 SUPPORTED COPPER CATALYSTS

Theoretical Investigation on the CO2 Hydrogenation to Methanol Mechanism at Electron-Rich Active Interface over Cu/Ga-Ti-Al-O Catalyst

Low-temperature methanol synthesis catalyzed over Cu/γ-Al2O3–TiO2 for CO2 hydrogenation

The studies of methanol synthesis over the titanium-modified γ-alumina-supported CuO catalysts from CO2 hydrogenation

Methanol Synthesis from CO2 Hydrogenation over a Novel Titanium-Modified Γ-Al2o3 Supported Copper Catalyst

Low-Temperature Methanol Synthesis Catalyzed Over Cu/Gamma-Al2o3-Tio2 For Co2 Hydrogenation

Promoting effect of titanium on Cu/γ-Al2O3 catalyst for CO2 hydrogenation

Effect of support texture properties on Ni-Fe/γ-Al_2O_3 catalyst structure and catalytic performance for CO methanation

Promoting effect of titanium on Cu/gamma-Al2O3 catalyst for CO2 hydrogenation

Effects of Pore Structure on Methanol Selectivity in Carbon Monoxide Hydrogenation

Properties of Cu/ZnO/Al2O3 Catalysts Modified by Titanium Additives in Synthesis of Methanol from Syngas Using Orthogonal Experimental Design

Effect of Promoter TiO2 on the Performance of CuO-ZnO-Al2O3 Catalyst for CO2 Catalytic Hydrogenation to Methanol

Methanol Synthesis from CO2 Hydrogenation over Copper Catalysts Supported on MgO-modified TiO2

Titanium-Promoted Rh-Mn-Li/SiO2 for C2-Oxygenates Synthesis from Syngas: Effect of Low Titanium Loading

Improved charge transfer and morphology on Ti-modified Cu/γ-Al 2 O 3 /Al catalyst enhance the activity for methanol steam reforming

Improved Charge Transfer and Morphology on Ti-modified Cu/γ-Al2O3/Al Catalyst Enhance the Activity for Methanol Steam Reforming

Methanol Synthesis from CO2 Hydrogenation over Supported CuO/TiO2 Catalysts

The Effect of TiO 2 on the Catalytic Activity of a PtRu/C Catalyst for Methanol Oxidation