Abstract:For high-speed traveling-wave modulator, impedance match, velocity match and low microwave attenuation are important. But they have different effects on bandwidth for different structure and scheme for quantum well electroabsorption modulator and bulk Mach-Zehnder electrooptic modulator. For bulk Mach-Zehnder electrooptic modulator, the longer active waveguide is needed, and at such situation, according to the normalized gain (or modulation reduction factor) the velocity match and impedance match and low microwave attenuation should be well satisfied to achieve good performance. While for the quantum well electroabsorption modulator, limited by the optical loss, short active waveguide must be used. When the device length is largely reduced match requirement is not so strict and it is also difficult to achieve good match. Low terminator electroabsorption modulator is reported recently. Its concept could be inferred from the normalized gain formula. And some technology tendency in traveling-wave electroabsorption and Mach-Zehnder modulator could be also obtained and could explain series of experiment. From calculation and experiment the low impedance and low terminator could expand the bandwidth by slight mismatch. The relation of modulator characteristic impedance, microwave phase velocity and microwave attenuation is not much considered for simplification. The results are useful to design and optimize modulator.

Modulation Properties of Multi Quantum Wells Laser Analyzed by A Three-Level Model in Spice

Modeling of a Diode Side Pumped Cesium Vapor Laser MOPA System

Modeling of a diode transverse-pumped cesium vapor laser

Different Effects on Bandwidth for Traveling-Wave Quantum Well Electro-Absorption Modulator and Bulk Mach-Zehnder Electric-Opto Modulator

Microwave Properties of Coplanar Strips of MQW Mach-Zehnder Modulator with Finite Metallization Thickness and Conductivity

Effects of the Spatial Nonuniformity of Optical Transverse Modes on the Modulation Response of Vertical-Cavity Surface-Emitting Lasers

Large signal model of quantum-well lasers for spice

Rate Equation Analysis of High Speed Q-Modulated Semiconductor Laser

Design and Improvement of InP-based Traveling Wave Mach-Zehnder Modulator for Monolithic Integrated with V-cavity Laser

The effects of multiply quantum wells (MQW) on optical and electrical characteristics of AlGaAs lasers with separate confinement heterostructures (SCH)

Q-modulated Semiconductor Laser Using Deep Etched Subwavelength Trenches

Proposal for $Q$ -Modulated Semiconductor Laser

A small-signal equivalent-circuit model of quantum-well lasers based on three-level rate equations

Travelling wave analysis on high-speed performance of Q-modulated distributed feedback laser.

The Optical Waveguide Design Of Quantum Well Electroabsorption Optical Modulator

Linearity Comparison of Silicon Carrier-Depletion-Based Single, Dual-Parallel, and Dual-Series Mach–Zehnder Modulators

InGaAsP/InP Based Q-modulated Slotted Fabry-Perot Laser Employing Lossy Half-Wave Trenches

Theoretical analysis of InGaAsP/InGaAsP multiple-quantum-wells electroabsorption modulators for the application of high-speed low driving voltage integrated light source

Q-modulated Semiconductor Laser

High Speed Silicon Mach-Zehnder Modulator with Circuit Model Analysis

Design And Simulation Of 450nm Gan-Based Multiple-Quantum-Well Tunable V-Cavity Laser