Abstract:It is a great challenge to detect in-situ high-frequency vibration signals for extreme environment applications. A highly sensitive and robust vibration sensor is desired. Among the many piezoelectric materials, single-crystal lithium niobate (LiNbO3) could be a good candidate to meet the demand. In this work, a novel type of micro-electro-mechanical system (MEMS) vibration sensor based on a single crystalline LiNbO3 thin film is demonstrated. Firstly, the four-cantilever-beam MEMS vibration sensor was designed and optimized with the parametric method. The structural dependence on the intrinsic frequency and maximum stress was obtained. Then, the vibration sensor was fabricated using standard MEMS processes. The practical intrinsic frequency of the as-presented vibration sensor was 5.175 kHz, which was close to the calculated and simulated frequency. The dynamic performance of the vibration sensor was tested on a vibration platform after the packaging of the printed circuit board. The effect of acceleration was investigated, and it was observed that the output charge was proportional to the amplitude of the acceleration. As the loading acceleration amplitude is 10 g and the frequency is in the range of 20 to 2400 Hz, the output charge amplitude basically remains stable for the frequency range from 100 Hz to 1400 Hz, but there is a dramatic decrease around 1400 to 2200 Hz, and then it increases significantly. This should be attributed to the significant variation of the damping coefficient near 1800 Hz. Meanwhile, the effect of the temperature on the output was studied. The results show the nearly linear dependence of the output charge on the temperature. The presented MEMS vibration sensors were endowed with a high output performance, linear dependence and stable sensitivity, and could find potential applications for the detection of wide-band high-frequency vibration.

A Novel High Resolution Vibration Sensor Based on Laser Frequency Splitting Technology

Experimental Study Of Vibration Measurement Based On Laser Frequency Splitting Principle

An Approach for Vibration Measurement Based on Laser Frequency Splitting Technology

A High-Frequency Angular Vibration Calibration System Based on Phase Modulated Laser Interferometer Technique

Measurement of Machinery Vibration Using Laser Mode Split Technology

Subnanometer Resolution Displacement Sensor Based on a Grating Interferometric Cavity with Intensity Compensation and Phase Modulation

A High-Resolution Displacement Sensor Based on a Grating Interferometer with the Phase Modulation Technique

Noncontact Intelligent Vibrometer Based on Laser Triangulation

Micro-vibration measuring technology based on heterodyne interference

Dual Frequency Laser and Relative Measurement Technology in the 21st Century

Feedback Displacement Measurement System Using Dual-Frequency He-Ne Laser

Static and dynamic measuring method based on birefringence laser frequency splitting principle

Study of Displacement Measurement with Nanometer Resolution Based on Birefringent Dual-frequency HeNe Laser Power Turning

Two Novel Applications of Frequency Splitting Technology in Dual Frequency Laser and Displacement Sensor

Study of Displacement Sensing Based on Laser Mode Splitting by Intracavity Quartz Crystal Wedges of HeNe Lasers

A Displacement Sensor Combining Cavity Tuning of A Laser with A Piezoelectric Transducer'S Subdivision Technique for A Bidirectional Sampling on the Rising and Falling Flanks

Principle of A Novel Displacement Sensor Based on Infrared He-Ne Laser

Principle Of A Novel Displacement-Sensing He-Ne Laser With Self-Calibration And High Resolution

Femtometer-amplitude imaging of coherent super high frequency vibrations in micromechanical resonators

Low-frequency vibration measurement by a dual-frequency DBR fiber laser

High-Performance Piezoelectric-Type MEMS Vibration Sensor Based on LiNbO3 Single-Crystal Cantilever Beams