Abstract:Ultrahigh-frequency (UHF) antenna sensors are used extensively for partial discharge (PD) detection to diagnose insulation systems subjected to high dV/dt voltage waveforms, e.g., inverter-fed motors. Through frequency spectrum analysis and appropriate high-pass filtering, it is possible to remove the voltage source interference and reliably detect PD activity; however, it is still unclear whether the frequency content of the signals gathered is representative of the PD or of the sample under test, acting as a transmitting antenna. In this paper, a high-frequency electromagnetic simulation software is used to estimate the emission features of turn-to-turn insulation sample models. The radiation characteristics of samples with different lengths and types are analyzed and compared with experimental data. The results show that with an increase in the length of the insulation model, both the simulated resonant frequency and the frequency spectrum of the PD signal shift to lower frequencies. The influence of the change in the angle of the insulating sample on the frequency spectrum of the PD was negligible. It can be concluded that the radiation performance of the insulating sample as a transmitting antenna affects the PD time-frequency spectrum distribution characteristics released by the test sample. In a hairpin motor stator, the lowest peak of the PD spectrum is predicted correctly by the simulated S11 response of the winding. The structural parameters of the equipment under test determine the radiation characteristics. The results can provide a basis for the frequency-domain analysis of PD, which is conducive to the extraction of characteristic parameters of PD signals and will improve the identification accuracy of PD defect types.

Characteristics of ultra-wideband partial discharge of insulation in aging process

Degradation Diagnosis of Large Stator Winding Insulation Based on Ultra-Wide Band Partial Discharge Detecting Technique

Assessment of stator winding insulation degradation in large generator by ultra-wideband PD detection

Radio-frequency Detection of Partial Discharge in Power Cable Joints

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Inference of PD in electrical insulation by charge-height probability distribution. Diagnosis of insulation system degradation

The Degradation Assessment of Epoxy/mica Insulation under Multi-Stresses Aging

Detection and Identification Technologies of Wide Band Partial Discharge

PD Electromagnetic Emission of Turn-to-turn Insulation in Inverter-fed Motor

Partial Discharge Characteristics in Oil-Paper Insulation under Combined Ac-Dc Voltage

Evaluation of the UHF Method Based on the Investigation of a Partial Discharge Case in Post Insulators

Mechanism Characterization and Nondestructive Inspection Method of Thermal Degradation Faults in EPDM Cable Termination

Investigation of partial discharge characteristics in XLPE cable insulation under increasing electrical stress

A Comparative Study of Time-Evolution Characteristics of Single and Double Cavity Partial Discharges

Partial Discharge Wideband Full-Band High-Gain Resonant Cavity UHF Sensor Research

Characteristics and Identification of Partial Discharge for Insulation Structures in High Voltage IGBT Modules Under Positive Square Wave Voltage

Partial Discharge Behavior of Epoxy/paper Insulated Tubular Busbars with Artificial Defects

The Characteristics and Detection of the Partial Discharge Induced by the Micro Cracks in GIS Insulators

Pd Pulse Burst Characteristics in Differently Aged Transformer Oils under Ac Conditions

Partial Discharge Characteristics of Typical Insulation Defect under AC and Impulse Superimposed Voltage in SF6 Gas

Investigation of Frequency Characteristics of Typical PD and the Propagation Properties in GIS