Abstract:Ultrahigh-frequency (UHF) antenna sensors are used extensively for partial discharge (PD) detection to diagnose insulation systems subjected to high dV/dt voltage waveforms, e.g., inverter-fed motors. Through frequency spectrum analysis and appropriate high-pass filtering, it is possible to remove the voltage source interference and reliably detect PD activity; however, it is still unclear whether the frequency content of the signals gathered is representative of the PD or of the sample under test, acting as a transmitting antenna. In this paper, a high-frequency electromagnetic simulation software is used to estimate the emission features of turn-to-turn insulation sample models. The radiation characteristics of samples with different lengths and types are analyzed and compared with experimental data. The results show that with an increase in the length of the insulation model, both the simulated resonant frequency and the frequency spectrum of the PD signal shift to lower frequencies. The influence of the change in the angle of the insulating sample on the frequency spectrum of the PD was negligible. It can be concluded that the radiation performance of the insulating sample as a transmitting antenna affects the PD time-frequency spectrum distribution characteristics released by the test sample. In a hairpin motor stator, the lowest peak of the PD spectrum is predicted correctly by the simulated S11 response of the winding. The structural parameters of the equipment under test determine the radiation characteristics. The results can provide a basis for the frequency-domain analysis of PD, which is conducive to the extraction of characteristic parameters of PD signals and will improve the identification accuracy of PD defect types.

Assessment of stator winding insulation degradation in large generator by ultra-wideband PD detection

Degradation Diagnosis of Large Stator Winding Insulation Based on Ultra-Wide Band Partial Discharge Detecting Technique

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Stator Fault Detection Of Doubly-Fed Induction Generators Using Rotor Instantaneous Power Spectrum

Experimental Study of Partial Discharge Pulses Propagation in Stator Winding of Hydro Generator

PD Electromagnetic Emission of Turn-to-turn Insulation in Inverter-fed Motor

Evaluation of the Degradation of Generator Stator Ground Wall Insulation under Multistresses Aging

The Degradation Assessment of Epoxy/mica Insulation under Multi-Stresses Aging

Aging Extent Assessment of Insulation Based on Velocity Measurement of Ultrasonic Longitudinal Wave Propagated in Stator Insulation

Estimating the remaining BDV for large generator stator winding by using nondestructive insulation diagnostic data based on statistical method

Discussion on the relation between residual breakdown voltage and nondestructive parameters of stator insulation in generator

Evaluation of the UHF Method Based on the Investigation of a Partial Discharge Case in Post Insulators

Detection and Identification Technologies of Wide Band Partial Discharge

Experimental study of the pulse propagation in turbine generator stator windings

Damage Identification of Large Generator Stator Insulation Based on PZT Sensor Systems and Hybrid Features of Lamb Waves

Inverter-Embedded Partial Discharge Testing for Reliability Enhancement of Stator Winding Insulation in Low Voltage Machines

A Study of the Pulse Propagation Behavior in a Large Turbo Generator

An Experimental Study on the Partial Discharge Model in Stator Windings Insulation of Generators

On Site Detection and Localization of Partial Discharge in Hydropower Plant GIL/GIS Based on Ultra-high Frequency Technique

Investigation of Frequency Characteristics of Typical PD and the Propagation Properties in GIS

An Online Groundwall and Phase-to-Phase Stator Insulation Monitoring Method for Inverter-Fed Machine.