Abstract:Using tert-butyl peroxy-2-ethyl hexanoate (TPRO) as initiator,the vinyl acetate (VAc) bulk grafting polymerization in the presence of polyethylene glycol (PEG) to get the PEG-g-PVAc was studied. The time evolution of polymerization rate,grafting ratio,grafting efficiency and molecular weight of the grafted copolymer were investigated respectively for various weight ratios of VAc to PEG. The results show that,with increasing VAc?PEG ratio,the polymerization rate and final conversion ratio are both enhanced,and an observable automatic acceleration phenomenon begins to appear. The overall reaction rate coefficient K increases with reaction time at higher VAc:PEG ratio,while a tendency of decrease of K with reaction time at lower VAc:PEG ratio was observed. At almost all VAc:PEG ratios,the grafting ratio was found to increase linearly with the conversion ratio,and the grafting efficiency keeps almost unchanged throughout the whole conversion. The grafting ratio is in proportion to VAc:PEG ratio,while the grafting efficiency is generally very high and can reach above 95% at low VAc?PEG ratio. Although the PEG grafted efficiency increases with both monomer consumption and rising VAc?PEG ratio,the overall PEG grafted efficiency is low,it indicates that a great amount of undrafted PEG exists. The phenomenon of high VAc grafting efficiency accompanying with low PEG grafted efficiency indicates that the 'Graft From' polymerization system may undergo a 'Graft Onto' mechanism. According to the definition,the PEG-g-PVAc number-average molecular weights were calculated,and the results show that the number-average molecular weights reduce at first with the increase of conversion ratio,and then approach to a constant; the higher the VAc?PEG ratio,the higher the number-average molecular weight. Via GPC analysis and PVAc universal calibration,the PDI (polydispersity index) of the grafted copolymer was determined to be between 1.5 ～ 2.5 and it aggrandizes with the increase of VAc concentration and conversion. It might be considered that,all these phenomena are related to the gel effect in the polymerization system.

Study on the crosslinking features of LDPE-AA vapor-phase photografting system

Study on the Mechanism of Ldpe-Aa Vapor-Phase Photografting System

Kinetic Study of Vinyl Acetate Graft Polymerization on PEG

Simultaneous Graft Polymerization of Polypropylene with Maleic Anhydride and Butyl Acrylate

Photo-grafting and cross-linking reaction of LDPE/acrylate polymerization systems

The Study of Melt Grafting Mechanism of Acrylic Acid and Butyl Acrylate Onto Low Density Polyethylene and Its Application As Internal Plasticizer

EFFECT OF THE ABSORPTIVE AMOUNT OF BENZOPHENONE ON SURFACE PHOTOGRAFTING OF ACRYLIC ACID ONTO HDPE

Improvement of Antifogging of Low Density Polyethylene Film by Photografting Acrylic Acid

UV Radiation Induced Grafting of Maleic Anhydride Onto Polyethylenes

Photografting of Acrylic Acid on High Density Polyethylene Powder in Vapour Phase

Study of LDPE/NVP system surface grafting polymerization

STUDIES ON PHOTOGRAFTING OF TRIMETHYLOL PROPANE TRIACRYLATE ONTO THE SURFACE OF LDPE FILMS

Surface Photografting Polymerization of Vinyl Acetate (vac), Maleic Anhydride, and Their Charge Transfer Complex. II. VAc(2)

Photo-grafting Poly(acrylic Acid) Onto Poly(lactic Acid) Chains in Solution

Surface Modification of Low-Density Polyethylene Films Via Photografting Polymerization Technique

Study on Surface Grafting Polymerization of Cpp/Aa System with Two-Step Method

Grafting Polymerization of Acrylonitrile onto LDPE Film: Study on Grafting Chain Length and Density with UV-vis Spectroscopy

Preparation of Temperature-Sensitive Polymer Films by Surface Photografting Techniques

Fluorinated acrylate-grafted LDPE films from UV-induced photograft polymerization

Photocross-linking of low-density polyethylene. I. Kinetics and reaction parameters

Vapor Phase Grafting of Vinyltrimethoxysilane and Its Crosslinking on Polypropylene