Abstract:In this work we argue that the reverse martensitic transformation (MT) of the stress-induced martensite (SIM) of Fe-Mn-Si-based alloys for moderate prestrains occurs in essentially thermoelastic-like way, in contrast to non-thermoelastic MT of temperature-induced martensite (TIM). We compare, using a number of complementary experimental techniques, the temperatures and the kinetics of the reverse ε→γ martensitic transformation of SIM and TIM for commercial and model Fe-Mn-Si alloys after various thermomechanical treatments. We claim that two studied phenomena are generic in Fe-Mn-Si-based alloys of different compositions and microstructure: first, opposite to the conventional effect of stabilization of martensite by prestrain, the reverse MT during heating of alloys prestrained in bending and tension starts well below (up to 100 K) the start temperature of the reverse MT for the TIM of the same alloy. The difference between engineering temperatures of the start of the reverse transformation, A s , for SIM and TIM reaches ca. 50 K, pointing to a need to consider different A s for TIM and SIM, and . Second, the reverse transformations of TIM and SIM show very different kinetics. The reverse MT of SIM is diffuse over the temperature range exceeding 100 K. The reverse MT of TIM, on the contrary, is well localized within the temperature range of ca. 20 K. The experimental observations can be interpreted assuming that, due to the differences in the formation mechanisms of SIM and TIM, the latter shows non-thermoelastic behaviour, whereas the SIM shows similarities with the thermoelastic martensites stabilized by prestrain.

Investigation on the Internal friction of reverse martensitic transformation in Fe-Mn-Si based alloys

Stabilization of deformed stress-induced martensite and its effect on shape memory effect in an Fe-Mn-Si-Ni-Co alloy

Modulus Softening During the Γ→ɛ Martensitic Transformation in Fe–25Mn–6Si–5Cr–0.14N Alloys

fcc Antiferromagnetism and martensitic transformation m Fe-Mn-Si based alloys

Reverse transformation characteristics of thermally induced ε(hcp) martensite in an Fe-Mn-Si based alloy

Study of Stabilization of CuAlBe Alloy During Martensitic Transformation by Internal Friction

Reverse transformation characteristics of thermally induced epsilon(hcp) martensite in an Fe-Mn-Si based alloy

In Situ Observation of Thermoelastic Martensitic Transformation of Cu-Al-Mn Cryogenic Shape Memory Alloy with Compressive Stress

The Investigation Of Internal Friction On Antiferromagnetic Transition And Martensitic Transformation In Mn-Fe(Cu) Alloys

A STUDY OF INTERNAL FRICTION ASSOCIATED WITH THE MARTENSITE TRANSFORMATION AT LOW FREQUENCY

A Study of Friction-Induced Martensitic Transformation for Austenitic Manganese Steel

THE BEHAVIOR OF INTERNAL FRICTION ASSOCIATED WITH THE PROCESS OF MARTENSITE-TYPE TRANSFORMATION

Mechanism of Stress Induced γ→ε Martensite Transformation in an Fe-Mn-Si Shape Memory Alloy

A method of discrimination between stress-assisted and strain-induced martensitic transformation using atomic force microscopy

Internal Friction and Modulus Changes Associated with Martensitic and Reverse Transformations in a Single Crystal Ni48.5Mn31.4Ga20.1 Alloy

Reverse ε→γ transformations of temperature-induced and stress-induced martensites in Fe-Mn-Si alloys with shape memory effect

Analysis of the Stress-Strain Curves of a Fe-Mn-Si Shape Memory Alloy

IN SITU RESISTANCE ANALYSIS ON TRANSFORMATION OF CONSTRAINED Fe-Mn-Si-Cr-Ni SHAPE MEMORY ALLOY

A micro-mechanical model of non-thermo-elastic martensitic transformation

The effect of thermal-mechanical training on the formation of stress-induced ϵ martensite in an FeMnSiNiCo alloy

Internal Friction Behaviors of Ni-Mn-In Magnetic Shape Memory Alloy with Two-Step Structural Transformation