Abstract:In a previous study, we presented a novel manufacturing process for the creation of 6 × 6 and 8 × 8 microlens arrays (MLAs) comprising lenses with diameters of 1000 μm, 500 μm, and 200 μm within an area that covers 10 mm × 10 mm. In the current study, we revised the manufacturing process to allow for the fabrication of MLAs of far higher density (15 × 15 and 29 × 29 within the same area). In this paper, we detail the revised manufacturing scheme, including the micromachining of molds, the partial-curing polydimethylsiloxane (PDMS) bonding used to fuse the glass substrate and PDMS, and the multi-step casting process. The primary challenges that are involved in creating MLAs of this density were ensuring uniform membrane thickness and preventing leakage between the PDMS and glass substrate. The experiment results demonstrated that the revised fabrication process is capable of producing high density arrays: Design I produced 15 × 15 MLAs with lens diameter of 0.5 mm and fill factor of 47.94%, while Design II produced 29 × 29 MLAs with lens diameter of 0.25 mm and fill factor of 40.87%. The partial-curing PDMS bonding system also proved to be effective in fusing PDMS with glass (maximum bonding strength of approximately six bars). Finally, the redesigned mold was used to create PDMS membranes of high thickness uniformity (coefficient of variance <0.07) and microlenses of high lens height uniformity (coefficient of variance <0.15).

Step heat-forming photoresist method for expanding the N. A. range of refractive microlens

Transmission of refractive microlens array by reactive ion beam etching

Design of Large Field of View and High Numerical Aperture Microscope Objective

In Situ Fabrication of a Tunable Microlens.

Fabrication of Multifocal Microlens Array by One Step Exposure Process

100% Fill-Factor Aspheric Microlens Arrays (AMLA) with Sub-20-nm Precision

Mask-Moving-Lithography-Based High-Precision Surface Fabrication Method for Microlens Arrays

Morphology adjustable microlens array fabricated by single spatially modulated femtosecond pulse

Theory and experiment study of micro/nano photothermal expansion

Super-Resolution Optical Microscopic Imaging Method Based on Annular Illumination with High Numerical Aperture

Progress In Femtosecond Laser Fabrication Of Microlens Array With Spatial Light Modulators

An Ultraviolet-Lithography-Assisted Sintering Method for Glass Microlens Array Fabrication

Theoretical Modeling of Microscopic Photothermal Expansion and Experimental Study of Photothermal Microactuators

A Novel Fabricating Method of Micro Lens-on-Lens Arrays with Two Focal Lengths

High Numerical Aperture Microlens Arrays Of Close Packing

Fabrication of Large-Area Silicon Spherical Microlens Arrays by Thermal Reflow and ICP Etching

Control of Diameter and Numerical Aperture of Microlens by a Single Ultra-Short Laser Pulse

Concave Microlens Array Mold Fabrication in Photoresist Using UV Proximity Printing

Controllable Preparation of Fused Silica Micro Lens Array through Femtosecond Laser Penetration-Induced Modification Assisted Wet Etching

Method of microlens array fabricated by inorganic photoresist

Using Micromachined Molds, Partial-curing PDMS Bonding Technique, and Multiple Casting to Create Hybrid Microfluidic Chip for Microlens Array