Abstract:Changes in chemical state and structural transformations occurring in a series of MOx/CeO2 (M = Cu, Ni and Fe) powder catalysts upon reaction with methane were investigated using in situ time-resolved Xray diffraction (TR-XRD), ex situ X-ray absorption near edge structure (XANES)/extended X-ray absorption fine structure (EXAFS) spectroscopy, and X-ray photoelectron spectroscopy (XPS). XPS shows the presence of adsorbed CHx and COx species after exposing the powder catalysts to methane at room temperature. Temperature-programmed reduction (TPR) measurements point to reaction of the samples with methane and formation of CO, CO2, and H2O gas at temperatures as low as 100 degrees C. The TR-XRD results show that all of the transition-metal oxides in the as-prepared catalysts can be reduced to their metallic phase during the CH4-TPR process with the ceria support undergoing significant reduction from surface to bulk, yet the reduction temperature varies for different MOx/CeO2 samples. Among these samples, CuOx/CeO2 shows the lowest reduction temperature (below 260 degrees C) for both the oxide overlayer and the ceria support. The NiOx/CeO2 and CoOx/CeO2 powder catalysts also activate CH4 at relatively low temperatures (below 350 degrees C), and the oxide overlayers undergo NiO -> Ni and Co3O4 -> CoO -> Co transformations. In the case of FeOx/CeOv, a series of complex changes in chemical state is observed for the oxide overlayer, Fe2O3 -> Fe3O4 -> FeO -> Fe -> Fe3C. The ceria support of the three MOx/CeO2 (M = Cu, Ni, and Fe) samples undergoes severe reduction and forms Ce2O3 at high temperature (>650 degrees C) during the CH4-TPR reaction. The in situ TR-XRD results highlight a rich and complex chemistry for methane on these MOx/CeO2 mixed oxide systems.

Investigation on the reduction process of Fe-Ce oxides by TRP-in situ Mössbauer spectroscopy

Temperature-programmed reduction and reduction kinetics of Mo-Ce oxides

Investigation on the redox/acidic features of bimetallic MOF-derived CeMOx catalysts for low-temperature NH3-SCR of NOx

The Reduction of Mg–Fe–O and Mg–Fe–Al–O Complex Oxides Studied by Temperature-Programmed Reduction Combined with in Situ Mössbauer Spectroscopy

The Reduction Behavior of Fe-Mo-O Catalysts Studied by Temperature-Programmed Reduction Combined with in Situ Mössbauer Spectroscopy and X-Ray Diffraction

A study on the reduction behavior of Fe2(MoO4)3 with a combined in-situ temperature-programmed reduction-M?ssbauer spectroscopic technique

CO and Methane Oxidation Over CeXZr1-XO2 Mixed Oxide Supported PdO Catalysts

Studies of TPR in situ Fe-57 MBS on the reduction behavior of the gamma-Al2O3 supported iron and platinum-iron catalysts

A Study of In-Situ Mössbauer Spectroscopy on Fe−Mo Oxides for Selective Oxidation of Toluene

MOF-Derived CeO2 and CeZrOx Solid Solutions: Exploring Ce Reduction through FTIR and NEXAFS Spectroscopy

Soot Combustion Performance and H2-TPR Study on Ceria-Based Mixed Oxides

Reaction of Methane with MOx/CeO2 (M = Fe, Ni, and Cu) Catalysts: in Situ Studies with Time-Resolved X-ray Diffraction

Study of Pt Dispersion on Ce Based Supports and the Influence on the CO Oxidation Reaction

Study on the Structure and Reduction Behaviour of the Iron–zirconium Oxide System

Co Oxidation Activity and Tpr Characterization of Ceo2-Supported Manganese Oxide Catalysts

Reactive behaviors of iron-based shift catalyst promoted by ceria

Study on the Reduction Behavior of Zirconia Supported Iron Oxide Catalysts by Temperature-Programmed Reduction Combined within SituMössbauer Spectroscopy

A study on the reduction behavior of silica supported iron and platinum-iron catalysts

Comparison of Reduction Behavior of Fe2O3, ZnO and ZnFe2O4 by TPR Technique

A study on reduction behaviors of the supported platinum–iron catalysts

Does H2 Temperature‐Programmed Reduction Always Probe Solid‐State Redox Chemistry? The Case of Pt/CeO2