Abstract:In this paper, a feedback control mechanism and its optimization for rotating disk vibration/flutter via changes of air-coupled pressure generated using piezoelectric patch actuators are studied. A thin disk rotates in an enclosure, which is equipped with a feedback control loop consisting of a micro-sensor, a signal processor, a power amplifier, and several piezoelectric (PZT) actuator patches distributed on the cover of the enclosure. The actuator patches are mounted on the inner or the outer surfaces of the enclosure to produce necessary control force required through the airflow around the disk. The control mechanism for rotating disk flutter using enclosure surfaces bonded with sensors and piezoelectric actuators is thoroughly studied through analytical simulations. The sensor output is used to determine the amount of input to the actuator for controlling the response of the disk in a closed loop configuration. The dynamic stability of the disk-enclosure system, together with the feedback control loop, is analyzed as a complex eigenvalue problem, which is solved using Galerkin’s discretization procedure. The results show that the disk flutter can be reduced effectively with proper configurations of the control gain and the phase shift through the actuations of PZT patches. The effectiveness of different feedback control methods in altering system characteristics and system response has been investigated. The control capability, in terms of control gain, phase shift, and especially the physical configuration of actuator patches, are also evaluated by calculating the complex eigenvalues and the maximum displacement produced by the actuators. To achieve a optimal control performance, sizes, positions and shapes of PZT patches used need to be optimized and such optimization has been achieved through numerical simulations.

Investigation on the vibration resistance of optical head in the optical disk

Performance test of optical and electronic image stabilizer for digital imaging system

Piezoelectric Shunt Damping for the Read/Write Arm in Hard Disk Driver

Analysis of Vibration Sensitivity Induced by the Elastic Deformation of Vertical Optical Reference Cavities

MODAL TESTING AND FINITE ELEMENT MODELLING OF SUBSYSTEM IN HARD DISK DRIVE

Vibration Suppression Of A Hard Disk Driver Actuator Arm Using Piezoelectric Shunt Damping With A Topology-Optimized Pzt Transducer

Optimization of Sensing and Feedback Control for Vibration/Flutter of Rotating Disk by PZT Actuators Via Air Coupled Pressure

Nano-and Micro-Actuations of Hard Disk’s Head Positioning System: Actuator Design and Evaluation of Performance

In Situ Measurement of Seeking Speed and Seeking Induced Head-Disk Interface Instability in Hard Disk Drives

Tests and Modeling of a New Vibration Isolation and Suppression Device

Testing of Optical Disk Axial Run-Out and Tilt

Measurement Of Dynamic Properties Of Optical Disk Cluster Drive Using Virtual Instruments

Adaptive Suppression Of High-Frequency Wide-Spectrum Vibrations With Application To Disk Drive Systems

An experimental study of slider flying vibration at nano-meter head-disk spacing

Effect of Low-Frequency Vibration in Z-Direction (Out-of-Plane) on Slider Dynamics

Movement Dynamics Analysis for an Optical Pickup Head Lens Actuator in A Digital Versatile Disc System

Contact Induced Off-Track Vibrations of Air Bearing-Slider-Suspension System in Hard Disk Drives

Design and Verify of the Micro-vibration Isolation System for a Space-born High Sensitivity Optical Payload

Numerical study on energy transmission for rotating hard disk systems by structural intensity technique

A New Detecting Method of Radial Tilt and Plane Vibration of Disk

Design and Experimental Research on Isolation Mechanism for Opto-Electronic Platform in Moving Carries