The influence of components on the high‐temperature performance and cutting performance of Si3N4‐based ceramic tools
Weiwei Xu,Zuoxuan Zhang,Boxiang Wang,Liyi Jiang,Guodong Yan,Li Guan
DOI: https://doi.org/10.1111/ijac.14924
2024-09-27
International Journal of Applied Ceramic Technology
Abstract:In this paper, we tested the mechanical properties at room and high temperatures, and compared the cutting performance of three ceramic tool materials with different components added sequentially. By analyzing and comparing, the influence of material components on the changes in material mechanical properties and cutting performance is obtained, and the guidance for material system design is proposed. Three kinds of Si3N4‐based ceramic tools (single‐phase Si3N4, Si3N4/(W,Ti)C, and Si3N4/(W,Ti)C/Ni) were fabricated by microwave sintering. The phase composition, toughening mechanism, mechanical properties at room and high temperatures (800°C), and cutting performance of Si3N4‐based ceramic tool materials with different additives were investigated. The results showed that the addition of (W,Ti)C and Ni had a significant effect on improving the mechanical properties at room temperature, although it reduced the phase transition conversion rate of Si3N4. Si3N4/(W,Ti)C tools had good high‐temperature stability, while Si3N4/(W,Ti)C/Ni tools had a decrease of about 31.6% in high‐temperature hardness and a decrease of 13.7% in high‐temperature flexure strength. Under the premise of ensuring a certain level of fracture toughness, high‐temperature hardness is the main influencing factor on the cutting life of cutting tools. The Si3N4/(W,Ti)C tools exhibit superior cutting performance whose cutting life reaches to 50.67 min which was 1.37–3.27 times longer than the other two ceramic cutting tools at the same cutting parameters when continuous dry cutting T10A. In addition, high‐temperature flexure strength limits the choice of cutting speed, and lower high‐temperature flexure strength can lead to rapid tool failure.
materials science, ceramics