Abstract:We propose and demonstrate a novel technique that uses a FabryPerot laser diode (FPLD) to perform simultaneous alloptical individual channel clock extraction and wavelength conversion. The nonlinear dynamical period1 oscillation can occur when a semiconductor laser is optically injected. By utilizing the crossgain modulation effect and the period1 oscillation harmonic frequencylocked in an optically injected semiconductor laser, we can extract the wavelength conversional individual channel optical clock from the opticaltimedivisionmultiplexing (OTDM) signal. In a FPLD, we numerically simulate the extraction of 20 GHz optical clock at 1550 nm from the 2×20 Gb/s OTDM signal at 1555 nm, and experimentally obtain the -105 dBc/Hz phase noise frequency division clock of 1236 GHz to 618 GHz with simultaneous wavelength conversion from 155024 nm to 154591 nm. Moreover, we investigate the influence of the injection optical power level, wavelength detuning, the FPLD's bias current level and the longitudinal mode selection on the optical clock extraction. This method is potential to technologically apply in the alloptical demultiplexing and wavelength routing in the OTDM mixed wavelengthdivisionmultiplexing (WDM) communication system.

Clock component extraction from unequal amplitude signals in time division multiplexing using SLALOM

A Novel Multiphase Clock Generator Based on Digital DLL Designed for Oversampling in Transceiver

Optical time division multiplexing demultiplexing of 4×2.5 GHz using SLALOM

Simultaneous Clock Component Extraction and Wavelength Conversion of NRZ Signal Using an SOA Loop Mirror

Chirping compensation using semiconductor laser amplifiers

All Optical Clock Extraction And Demultiplexing In 4x10ghz Otdm System

All Optical Clock Extraction and Demultiplexing in 4×10 GHz OTDM System

8X2.5-Gb/s OTDM Data Demultiplexing Using an SLALOM

Optical Clock Extraction And Self-Routeing Using A Semiconductor Nonlinear Multilayer Structure

Analysis and Modeling of Mueller–Muller Clock and Data Recovery Circuits

A Novel All-Optical Clock Recovery Experiment for Extracting Clock Signal from OTDM Signal

Comb-like Filter Preprocessing to Reduce the Pattern Effect in the Clock Recovery Based on SOA

Simultaneous all-optical individual channel clock extraction and wavelength conversion using an optically injected Fabry-Perot laser diode

Experimental Demonstration of Clock Component Extraction of NRZ Signal Using SOA Loop Mirror

Investigation Of Optical Clock Division And Demultiplexing Based On A Commercial Lithium Niobate-Intensity Modulator

Theoretical and Experimental Analysis of Channel Mismatch in Time-Wavelength Interleaved Optical Clock Based on Mode-Locked Laser

All Optical Clock Division and Multiplication by Injection Mode-Locked Laser Based on SOA

Combination of Comb-Like Filter and SOA for Preprocessing to Reduce the Patten Effect in the Clock Recovery

All-optical Clock Division with Mode-Locked Figure-Eight Laser Based on the Slow Carrier Recovery Rate in Semiconductor Optical Amplifier

Using Signal Pre-Distortion to Enhance the Performance of All-Optical Clock Recovery