Abstract:We demonstrate 40 Gb/s all-optical clock recovery by using a monolithic integrated amplified-feedback laser (AFL) with coherent injection-locked method. The AFL consists of a gain-coupled DFB laser and an optical amplified feedback external cavity. With proper design and operation of AFL, the device can work at self-pulsation state that resulted from the beating between two lasing modes. The self-pulsation can be injection-locked to the optical clock embedded in input data streams. Due to different work mechanisms, there are two all-optical clock recovery operation modes: incoherent injection-locked and coherent injection-locked. It's predicted that the coherent injection method has various advantages: 1) requiring low injection power recovery, 2) independent of the bit rate and 3) introducing little timing jitter to the recovered clock. The robustness of coherent clock recovery is confirmed by our experimental results. We set up a return-to-zero (RZ) pseudorandom binary sequence (PRBS) data streams all-optical clock recovery system. This coherent injection-locked based clock recovery method is optical signal noise ratio (OSNR) and chromatic dispersion (CD) degeneration tolerant, and has low timing jitter and high sensitivity.

All-optical Clock Division with Mode-Locked Figure-Eight Laser Based on the Slow Carrier Recovery Rate in Semiconductor Optical Amplifier

All-Optical Clock-Division Operation Using A Mode-Locked Fiber Laser Based on the Slow Carrier Recovery Rate of Soa

All Optical Clock Division and Multiplication by Injection Mode-Locked Laser Based on SOA

All-optical frequency multiplication/recovery based on the semiconductor optical amplifier ring cavity

0.6mW 6.3 GHz 40nm CMOS divide‐by‐2/3 prescaler using heterodyne phase‐locking technique

40 Gb/s Clock Recovery Based on Optical Phase-Locked Loop

All-optical Subharmonic Clock Recovery Using an Injected Mode-locked Fiber Ring Laser

All-optical clock recovery using a ridge width varied two-section partly gain-coupled DFB self-pulsation laser

All-Optical Clock Recovery for 20 Gb/s Using an Amplified Feedback DFB Laser

Low timing jitter 40 Gb/s all-optical clock recovery based on an amplified feedback laser diode

All Optical Clock Extraction And Demultiplexing In 4x10ghz Otdm System

Generation of Optical Period-Doubling Sequence in Fiber Laser with a Semiconductor Laser Amplifier in Loop Mirror

Effective Optical Clock Recovery and Simultaneous Fourfold Demultiplexing of Otdm Signal Using an Optoelectonic Oscillator

A Novel Technology to Reduce the Pattern Effect in All-Optical Clock Recovery Using Injected Mode-Locked Laser Based on Soa

100-GHz wavelength-tunable all-optical clock recovery with Fabry-Perot filter and semiconductor optical amplifier

All Optical Clock Extraction and Demultiplexing in 4×10 GHz OTDM System

Wavelength-Spacing Tunable Multi-Wavelength Erbium-Doped Fiber Laser Incorporating A Semiconductor Optical Amplifier

100 Gb/s All-Optical Clock Recovery Based on a Monolithic Dual-Mode DBR Laser

All-optical Clock Recovery Using Parallel Ridge-Width Varied DFB Lasers Integrated with Y-branch Waveguide Coupler

Multi-wavelength mode-locked fiber ring laser operating in L-band with semiconductor optical amplifier