Abstract:The fabrication process of integral ceramic mold based on stereolithography and gelcasting can eliminate the assembly errors between cores and that between cores and shell in the traditional manufacturing process of ceramic molds. However, the bending strength of the mold at 500 degrees C (mid-temperature strength) drops significantly during pre-sintering because the gel networks surrounded the ceramic particles are burnt off, which often causes the core fracture or shell cracking of the integral ceramic mold. In this paper, short alumina-based fibers were added into the gelcast ceramic slurry to improve the mid-temperature of the ceramic mold. Filling experiment and computed tomography (CT) test were performed to investigate the effect of fiber content and fiber length on the filling ability of ceramic slurry in the cavity with small complex structures. The mid-temperature strengths of the ceramic mold were tested. Microstructures of the ceramic mold sintered at 500 degrees C were observed by scanning electron microscope (SEM). It was found that the filling ability of the ceramic slurry decreased as the fiber length and fiber content increased, however the mid-temperature strength of the ceramic mold increased with the fiber length and fiber content. When 1.5wt% short alumina-based fibers with lengths between 0.5 mm and 1 mm were added, the ceramic slurry could meet the requirement of gelcasting, and the mid-temperature strength of the ceramic mold was improved from 0.78 MPa to 1.65 MPa.

The Effect of Boehmite on Electrokinetic Behaviours, Rheology and Coagulation for Direct Coagulation Casting of Alumina

Natural additives in protein coagulation casting process for improved microstructural controllability of cellular ceramics

Direct coagulation casting of alumina slurry and its technics

Direct coagulation casting of alumina suspension by high valence counter ions using Ca (IO 3) 2 as coagulating agent

Direct Coagulation Casting of Alumina Suspension from Calcium Citrate Assisted by Ph Shift

Direct Coagulation Casting of Positively Charged Alumina Suspension by Controlled Release of High Valence Counter Ions from Calcium Phosphate

Direct coagulation casting of alumina using magnesium citrate as coagulating agent with glycerol diacetate as pH regulator

Alumina-Based Ceramic Core Nano-Composites For Investment Casting

Hydrolysis‐induced Simultaneous Foaming and Coagulation Casting of Secondary Aluminum Dross Aqueous Suspension

Microstructures and High-Temperature Strength of Gel-Casting Al2O3-based Ceramic Molds with Coated Aluminum Additive

Gelcasting of Alumina with a Mixed PVP–MAM System

Effect Of Alumina-Based Fiber On The Mid-Temperature Strength Of Integral Ceramic Mold For Casting Hollow Turbine Blade

Properties of Alumina Coagulated Bodies Prepared by Direct Coagulation Casting Via High Valence Counter Ions (DCC‐HVCI)

Gelcasting of Alumina Based Ceramic Cores Containing Yttria for Single Crystal and Directional Solidification Blades

Gelcasting of alumina ceramics in the mixed acrylamide and polyacrylamide systems

Direct ink writing additive manufacturing of porous alumina-based ceramic cores modified with nanosized MgO

Direct coagulation casting of alumina via controlled release of calcium from ammonium polyphosphate chelate complex

Reliable High Strength Alumina Fabricated by DCC-HVCI Using Submicron Calcium Citrate Complex

Effect of Dispersants on the Rheological Properties and Slip Casting of Concentrated Alumina Slurry

Direct coagulation casting of alumina suspension via controlled release of high valence counterions from thermo-sensitive liposomes

Gelcasting of Alumina Via Cross-Linking of a Polyelectrolyte Dispersant