Abstract:The inorganic powder slurry extrusion printing technique known as robocasting is an interesting method to fabricate complex porous architectures whereby feedstocks containing organic binders and powders are printed and the resulting scaffolds are subjected to sintering. A major limiting factor of this technique is the simultaneous tailoring of vascularization efficacy and osteogenic activity, usually done by adding the secondary phase in the organic slurry before the writing step. Mechanical mixing of biphasic powders is required to avoid compromising the biological performance and physical defects caused by significantly different physicochemical properties. This study addresses this issue by developing a selective ion doping and microstructure tuning for the production of bioceramic scaffolds with a binozzle robocasting process. Different metal ions (Sr2+, Mg2+) were doped into wollastonite (CaSiO3; CSi) powders considering the mechanical stability and bioactive enhancement of the bioceramic scaffolds. Subsequently, the Mg-doped CSi slurries were used as shell-nozzle feedstocks added with 5, 10, and 15 μm diameter polystyrene microbeads that allowed shell-layer micropore production in pore struts during sintering. Finally, the most promising pore-strut microstructures and mechanical evolution of scaffolds were evaluated, and especially the enhanced fibrovascularization potential was confirmed in dorsal muscle embedding model in rabbits. This study may open an avenue to designing multiproperty-tuned macro- and microporous bioceramics for bone regenerative medicine, especially in challenging bone defect conditions.

Natural additives in protein coagulation casting process for improved microstructural controllability of cellular ceramics

Improvement of Microstructural Controllability of Cellular Ceramic for Multifunctional Composites

Effect of Foreign Ion Substitution and Micropore Tuning in Robocasting Single-Phase Bioceramic Scaffolds on the Physicochemical Property and Vascularization

Effect of starch addition on microstructure and properties of highly porous alumina ceramics

Controlling Porosity and Pore Size Distribution of Alumina Ceramics in Consolidation Forming Process Using Modified Starches

Rheological Behavior of Modified Starch-Alumina Oxide Suspensions

Colloidal In-Situ Consolidation Forming of Al2O3 Ceramics Using Modified Starch

Fabrication of Porous Alumina Ceramics by Starch Consolidation

Gelcasting of alumina ceramics using an egg white protein binder system

Colloidal In-Situ Consolidation Forming of Al<sub>2</sub>O<sub>3</sub> Ceramics Using Modified Starch

Novel Direct Coagulation Casting of Alumina Suspensions Using Y3+-Ion Releasing Substances As Coagulant

Application of Acetate Starch to Colloidal In Situ Consolidation Molding Process of Alumina Ceramic

Sintering additive on the pore structure and mechanical properties of Si 3N 4 ceramic foam produced by protein coagulation casting

Effect of Composite Sintering Additive on Al<sub>2</sub>O<sub>3</sub> Ceramic Foam

Relation Between Rheological and Curing Behavior of Inorganic Foam Slurries in the Gel-Casting Process

Effects of Starch on Properties of Alumina-based Ceramic Cores

Gelcasting of alumina ceramics in the mixed acrylamide and polyacrylamide systems

New gel-casting process for alumina ceramics based on gelation of alginate

The controllable microstructure of porous Al2O3 ceramics prepared via a novel freeze casting route

Direct ink writing additive manufacturing of porous alumina-based ceramic cores modified with nanosized MgO

Preparation of Homogeneous Mullite‐based Fibrous Ceramics by Starch Consolidation