Abstract:Response characteristics of the atomic absorption spectrometric detector and dispersion contributions of individual components of the flow injection atomic absorption spectrometry (Fl-AAS) system were studied using samples of less than 100-mu-l. The dispersion coefficient D, half steady-state time t1/2 and half steady-state volume V1/2 were used for evaluation. The transport conduits and sample loops in previously reported manifolds were found to be the main sources of sample dispersion. The detector studied had a t1/2 response time of 0.20 s, which was almost independent of the sample introduction rate. Dispersion effects in the nebulizer-burner system, which influence the response kinetics of the detector, generally showed a very limited contribution of the over-all dispersion of the injected samples. Knotted sample loops, and short transport conduits of 0.35 mm i.d., were used in an improved Fl sample introduction manifold in order to limit dispersion. By injecting 45 and 65-mu-l samples, 90 and 98%, respectively, of the steady-state signal from conventional sample aspiration were achieved. The precision and detection limits obtained by peak height measurement at an optimized carrier flow-rate of 4.2 ml min-1 were comparable to conventional methods and were better than peak area measurements by a factor of 2. An absolute detection limit of 3 ng was obtained for lead in the peak height mode with a 35-mu-l sample, compared with 80 ng by conventional steady-state measurements. Tolerance of a high content of dissolved solids in samples was improved and demonstrated by repeated determinations (65-mu-l injections) of 10-mu-g ml-1 of Pb in saturated lithium borate solution at 360 samples h-1 for 1 h with 0.9% relative standard deviation (RSD), and in 30% m/v NaCI solution at 180 samples h-1 with 2% RSD.

Studies on the Chemical Kinetics in Flow Injection Analysis System

Mathematical Model of the Dynamics of Countercurrent Chromatography

Establishment of a finite element model for extracting chemical reaction kinetics in a micro-flow injection system with high throughput sampling

Flow Injection Analysis Methods for Determination of Diffusion Coefficients

A Computational Fluid Dynamics Study of Binary Adsorption Separation in Chromatography

Experimental Analysis in Dynamics Characteristics of Impinging Spray by a PFI Injector : from Spray Atomization to Fuel Adhesion Formation

FLow-injection analysis: a new approach to quantitative measurements in clinical chemistry.

Critical Evaluation of the Efficiency and Synergistic Effects of Flow Injection Techniques for Sensitivity Enhancement in Flame Atomic Absorption Spectrometry

Determination of Diffusion Coefficients of Proteins by Flow Injection Analysis and Its Application to Estimation of Molecular Masses of Proteins

Flow injection analysis (FIA) — a personal view

Experience with flow-injection analysis in marine chemical research

Continuous Monitoring in Drug Dissolution Testing Using Flow Injection Systems

Investigation of the Concentration Dependence of Mass Transfer Coefficients in Reversed-Phase Liquid Chromatography

A New Flow Injection Single-Standard Calibration Method for Flame Atomic Absorption Spectrometry Based on Dilution by Microsample Dispersion

Flow injection analysis of inorganic cationic species in serum and urine

Parametric Study on Suspension Behavior in an Inductively Coupled Plasma

Direct Processing and Analysis of Solid and Other Complex Samples with Automatic Flow Injection Systems

Contribution of System Components to Dispersion in the Analysis of Microvolume Samples by Flow-Injection Flame Atomic-Absorption Spectrometry

Analysis of Samples with High Dissolved Solids Content Using Flow-Injection Flame Atomic-Absorption Spectrometry

A Second-Order Time-Accurate Method for Determination of Concentration Distribution of Multicomponent Mixtures in Separation Cascades

Combination of flow injection with capillary electrophoresis. Part I. The basic system