Abstract:Suspension plasma spray is a promising technology for surface coatings. In this work, a comprehensive numerical model was developed to investigate the multiphase flow of suspension droplets and nanoparticles in direct-current (DC) plasma spraying. A three-dimensional computational model was developed to describe the plasma jet flow fields coupled with the axial injection of suspension droplets in which the zirconia micro- and nanoparticles were dispersed. The suspension droplets were tracked using Lagrangian coordinates, considering particle heating, melting, and evaporation. After evaporation of the solvent surrounding the particle, the nanoparticles were discharged into the plasma flow. In addition to the viscous force exerted by the flow on the micrometer-sized particles, the Brownian force and the Saffman lift force were taken into account. The effects of the noncontinuum on particle momentum transfer and evaporation on heat transfer were also considered. The numerical predictions of gas flow temperature were compared with experimental data and numerical data obtained with a different computational fluid dynamics code. The agreement was reasonable. The trajectories, velocity, and temperature of nanoparticles were calculated, and compared with those of microparticles. The results showed that the Brownian force plays a major role in acceleration and heating of nanoparticles. Compared with the conventional plasma spray process with micrometer-sized feedstock, the nanoparticles in suspension plasma spraying were found to have a wider spatial distribution and higher temperature. The effects of operating parameters, such as the power input to the plasma gas and plasma gas composition, on the gas velocity and temperature were investigated. The parameters that have a significant effect on the heat and momentum transfer to the particles injected in the plasma jet were identified.

Parametric Study on Suspension Behavior in an Inductively Coupled Plasma

Numerical Modeling in Radio Frequency Suspension Plasma Spray of Zirconia Powders

Modeling of non-Newtonian suspension plasma spraying in an inductively coupled plasma torch

Modeling of Micro- and Nanoparticle Characteristics in DC Suspension Plasma Spray

Simulation of Effervescent Atomization and Nanoparticle Characteristics in Radio Frequency Suspension Plasma Spray

Nanoparticles Modeling in Axially Injection Suspension Plasma Spray of Zirconia and Alumina Ceramics

Dynamic Modeling of Micro- and Nano-Sized Particles Impinging on the Substrate During Suspension Plasma Spraying

Numerical Study of Particle In-Flight Characteristics in a RF Induction Plasma Spray

Numerical Investigation of Dynamic Properties of Plasma Sheath with Pitching Motion

Effects of Atomization Injection on Nanoparticle Processing in Suspension Plasma Spray

Numerical Simulation of Radio Frequency Induction Plasma Spray Processing

Kinetic simulations of low-pressure inductively coupled plasma: an implicit electromagnetic PIC/MCC model with the ADI-FDTD method

An Investigation of Particle Injection and Resulting In-Flight Particle Behavior During Air Plasma Spraying

Two-dimensional Model and Experimental Comparison of an Inductively Coupled Plasma

Quadrature Method of Moments for Nanoparticle Coagulation and Diffusion in the Planar Impinging Jet Flow

Two-Dimensional Simulation of Inductively Coupled Plasma Based on Comsol and Comparison with Experimental Data

Three-Dimensional Discharge Simulation of Inductively Coupled Plasma (icp) Etching Reactor

Experimental and Numerical Studies of Plasma Forming Process Parameters Effect on Optimum Particle Impact Locations

Particle simulation of collision dynamics for ion beam injection into a rarefied gas

Three-dimensional simulation of plasma spray: effects of carrier gas flow and particle injection on plasma jet and entrained particle behavior

Modeling Approach and Analysis of the Structural Parameters of an Inductively Coupled Plasma Etcher Based on a Regression Orthogonal Design