Abstract:Suspension plasma spray is a promising technology for surface coatings. In this work, a comprehensive numerical model was developed to investigate the multiphase flow of suspension droplets and nanoparticles in direct-current (DC) plasma spraying. A three-dimensional computational model was developed to describe the plasma jet flow fields coupled with the axial injection of suspension droplets in which the zirconia micro- and nanoparticles were dispersed. The suspension droplets were tracked using Lagrangian coordinates, considering particle heating, melting, and evaporation. After evaporation of the solvent surrounding the particle, the nanoparticles were discharged into the plasma flow. In addition to the viscous force exerted by the flow on the micrometer-sized particles, the Brownian force and the Saffman lift force were taken into account. The effects of the noncontinuum on particle momentum transfer and evaporation on heat transfer were also considered. The numerical predictions of gas flow temperature were compared with experimental data and numerical data obtained with a different computational fluid dynamics code. The agreement was reasonable. The trajectories, velocity, and temperature of nanoparticles were calculated, and compared with those of microparticles. The results showed that the Brownian force plays a major role in acceleration and heating of nanoparticles. Compared with the conventional plasma spray process with micrometer-sized feedstock, the nanoparticles in suspension plasma spraying were found to have a wider spatial distribution and higher temperature. The effects of operating parameters, such as the power input to the plasma gas and plasma gas composition, on the gas velocity and temperature were investigated. The parameters that have a significant effect on the heat and momentum transfer to the particles injected in the plasma jet were identified.

An Investigation of Particle Injection and Resulting In-Flight Particle Behavior During Air Plasma Spraying

Experimental and Numerical Studies of Plasma Forming Process Parameters Effect on Optimum Particle Impact Locations

Effect of Injection Angle on Particles In-Flight Characteristics

Study of Injection Angle and Carrier Gas Flow Rate Effects on Particles In-Flight Characteristics in Plasma Spray Process: Modeling and Experiments

In-Flight Particle Behavior in Internal Powder Injection Supersonic Plasma Spray

Effect of Process Parameters on Yttria‐Stabilized Zirconia Particles In‐Flight Behavior and Melting State in Atmospheric Plasma Spraying

Effects of Atomization Injection on Nanoparticle Processing in Suspension Plasma Spray

Modeling of Micro- and Nanoparticle Characteristics in DC Suspension Plasma Spray

Nanoparticles Modeling in Axially Injection Suspension Plasma Spray of Zirconia and Alumina Ceramics

Numerical Study of Particle In-Flight Characteristics in a RF Induction Plasma Spray

In-Flight Behaviors of Zro2 Particle in Plasma Spraying

Modeling of non-Newtonian suspension plasma spraying in an inductively coupled plasma torch

Three-dimensional simulation of plasma spray: effects of carrier gas flow and particle injection on plasma jet and entrained particle behavior

Effect of Processing Parameters on Plasma Jet and In-Flight Particles Characters in Supersonic Plasma Spraying

Retraction Of: In-Flight Analysis of Particles in Plasma Spraying

Generic Correlation Of Spray Distance With In-Flight Particle Behavior For Different Kinds Of Materials In Air Plasma Spraying

Dynamic Modeling of Micro- and Nano-Sized Particles Impinging on the Substrate During Suspension Plasma Spraying

The Analysis of Melting and Refining Process for In-Flight Particles in Supersonic Plasma Spraying

Investigation of Plasma Spraying with Internal Axial Powder Injection

Plasma-Particle Interaction in Spray Forming

Flow Characteristic of In-Flight Particles in Supersonic Plasma Spraying Process