Abstract:The effect of Bi2O3 on ZnO-based varistor ceramic sintered around 800 °C is still not fully understood, because most of the ceramic cannot reach full densification at this low-temperature. Therefore, (balanced) ZnO–0.5 mol% V2O5–0.5 mol% MnCO3–0.5 mol% Co2O3–0.5 mol% TiO2–xmol% Bi2O3 (x = 0, 0.01, 0.05, 0.1 and 0.2) ceramic was designed and prepared by the solid-state sintering at 800 °C. The effect of Bi2O3 variation on the microstructure and electrical nonlinearity of the sample material was studied by using methods of XRD SEM, STEM, EDS and E–J test. Bi2O3 can further activate the reaction at the interface between the V-rich liquid phase and ZnO grains during sintering. This enhanced interface reaction is the key reason to the extremely low-temperature sintering of the ceramic at 800 °C. The variation of Bi2O3 in the 0–0.2 mol% range barely influences the constituents of the ceramic, which consists of ZnO main phase and two other secondary phases: Zn3(VO4)2 and Zn2TiO4. Most of Bi2O3 tends to segregate at grain boundaries. As a result, a soaking time longer than 4 h is needed to allow Bi ions diffusing into enough grain boundaries and improving the nonlinearity of ZnO based varistor ceramic. The sample containing 0.01 mol% Bi2O3 and sintered at 800 °C for 8 h has the best properties of a 43.3 nonlinear coefficient, a 2300 V/mm breakdown voltage and a 0.13 mA/cm2 leakage current density.

Effects of sintering on formation of grain core and grain growth in ZnO varistor ceramics

Cold sintering ZnO based varistor ceramics with controlled grain growth to realize superior breakdown electric field

Microstructure and Electrical Properties of Ga2o3 Doping on Zno Varistor Ceramics with Different Sintering Temperature

Influence of Grain Size on Distribution of Temperature and Thermal Stress in ZnO Varistor Ceramics

Sintering Temperature Dependence of Grain Boundary Resistivity in a Rare‐Earth‐Doped ZnO Varistor

Effects of sub-grainboundaries on the characteristics of ZnO varistor ceramics

Effect of Minor Bi2O3 Doping on the Microstructure and Electrical Nonlinearity of the ZnVSnO Based Varistor Ceramics

Microstructure design and optimization of ZnO-Bi 2O 3-Sb 2O 3 based ceramic varistors

Effects of raw particle size and annealing on microstructure, electrical and mechanical behaviors of ZnO-based varistors

Microstructure Design and Optimization of ZnO-Bi2O3-Sb2O3 Based Ceramic Varistors

Effect of Fabrication Conditions on I–V Properties for ZnO Varistor with High Concentration Additives by Sol–gel Technique

Study on the electrical properties and defect structures of a high voltage gradient ZnO varistor

Elaboration and electrical characterization of ZnO-based varistor ceramics in different sintering temperatures

Structural and electrical properties of ZnO–V2O5–TiO2–Co2O3–MnO varistor ceramics with low sintering temperature

Influence of SnO2 on ZnO–Bi2O3–Co2O3 Based Varistor Ceramics

Effect of Bi2O3 on the ZnVMnCoTiO based varistor ceramic sintered at 800 °C

Effects of SiO2 on the microstructure and electrical properties of ZnO-based varistors (ZBSCCM) prepared by two-step sintering routework

Effects of Sintering Temperature and Holding Time on the Microstructure and Electric Properties of Ba(Zr0.3Ti0.7)O3 Ceramics

A New Method for Studying the Conduction Mechanism of ZnO-based Varistor Ceramics

Effects of SiO2 and B2O3 on electrical properties of low-temperature sintered ZnO–Bi2O3 varistors

Effect Of Quenching On Dielectric Properties Of Zno Varistor Ceramics