Abstract:The effect of strain-rate on plastic anisotropy of an HSLA340 steel sheet is investigated in the present paper. Uniaxial tension tests in seven different directions are performed under three strain-rates (one in quasi-static range and two in intermediate range). Flow stress and Lankford r-value are obtained from the test data to describe the plastic anisotropy of the material. Results show that the anisotropy varies with the increase in strain-rate. To model this rate dependent anisotropic behavior, three associated flow rule based yield functions, Hill48, Yld96, and Yld2000_2d, are employed first for each strain-rate. Though the result cannot match the test data perfectly, it still seems acceptable considering the complexity of the trend of anisotropy. Accordingly, the coefficients of these models are studied, and it turns out that all of them change with the stain-rate in a similar trend. Based on this result, a rate-effect term is introduced to the coefficients of the models to characterize the rate-effect on plastic anisotropy. Finally, two issues about the modeling work are discussed. One is calibrating the Yld96 and Yld200_2d model with the non-associated flow rule, which means the coefficients of the functions are determined by flow stress only or r-value only separately. It is found that the accuracy of the characterization is largely improved because of the increase in model coefficients. The other issue that is discussed is the modeling of strain-rate effect on the plastic anisotropy. A new strategy is considered, in which the strain-rate effects in different directions are characterized first, followed by the anisotropy description. The results of the two strategies are compared and good agreement is achieved.

Strain-dependence of plastic strain ratio of deep-drawing aluminium-killed steel sheet

Strain Ratio Effects on Low-Cycle Fatigue Behavior and Deformation Microstructure of 2124-T851 Aluminum Alloy

Prediction of Plastic Strain Ratio of Deep-Drawing IF Steel Sheets

Research on aluminum alloy sheet thermoplastic deformation behavior based upon warm bulging test

Anisotropy Study of Thin Metallic Sheets with Strain Measurement of Digital Speckle Correlation

Anisotropic plastic flow of low/medium carbon steel plates in different loading conditions: characterization of the r- value

Testing and Modeling the Effect of Strain-Rate on Plastic Anisotropy for A Traditional High Strength Steel

Equivalent characterization of pre-strained material properties and mechanical behavior prediction of steel/aluminum self-piercing riveted joints

A method for determining r-value of aluminum sheets with the Portevin-Le Chatelier effect

An Experimental Study on Strain Rate-Dependent Tensile Properties of Alumiunium L2

Strain Hardening under Large Deformation for AA5182

Prediction of Strain Path Changing Effect on Forming Limits of AA 6111-T4 Based on a Shear Ductile Fracture Criterion

Identification of forming performance parameters for 6016 aluminum alloy sheet under different strain paths via digital image correlation technology

Low-cycle fatigue behavior of Silafont®-36 automotive aluminum alloy: Effect of negative strain ratio

Investigation of the Flange Earring of Deep-Drawing Aluminum Sheets by Rate-Independent Polycrystalline Plasticity Finite Element Analysis

Correlation Between Uniaxial Tension Properties and Formability of Automotive Aluminium Alloy Sheet

Effect of Strain Ratio on Cyclic Deformation Behaviour of 7050-T6 Aluminium Alloy

Effect of Strain-Hardening on the Length of Plastic Zone of Steel Frames

Anisotropic Plasticity Behavior of Rolled 316L Ultra-Thin Sheet and Its Application to Micro-Deep Drawing Modeling

Large strain flow curve identification for sheet metals under complex stress states

Characterization of Portevin–Le Chatelier Effect in Aluminum Alloy AA5052 under Strain-Controlled Tensile Test Via Digital Image Correlation and Acoustic Emission