Effect of Oxygen Flow Rate, Post-annealing Temperature, and Different Electrolyte Concentrations on WO3 Thin Films Deposited by DC Magnetron Sputtering For Electrochromic Applications
K. Naveen Kumar,G. V. Ashok Reddy,Sheik Abdul Sattar,R. Imran Jafri,R. Premkumar,M. Muthukrishnan,A. Asrar Ahamed,M. R. Meera,Nunna Guru Prakash,Ammar M. Tighezza,Tae Jo Ko
DOI: https://doi.org/10.1007/s11664-024-11000-4
IF: 2.1
2024-03-18
Journal of Electronic Materials
Abstract:In this work, tungsten oxide (WO3) films were deposited at room temperature and annealed for 2 h at 400°C. The electrochromic and electrochemical properties were studied for two different electrolytes. The films were deposited at different oxygen flow rates of 2, 4, and 6 standard cubic centimeters per minute (SCCM). X-ray diffraction analysis revealed structural characterization of amorphous and crystalline phases. UV-visible spectroscopy optical transmittance revealed 91% transmittance, and energy-dispersive x-ray spectroscopy (EDS) analysis revealed the absence of impurities and the presence of W and O. An electrochemical analyzer was used to characterize the deposited and annealed WO3 films immersed in the two different electrolyte solutions (H2SO4 and LiClO4 with oxygen flow rates ranging from 2 SCCM to 6 SCCM). It was found that the H2SO4 electrolyte of an annealed WO3 thin film at 2 SCCM demonstrated high coloring efficiency of 50.18 cm2/C, and the LiClO4 electrolyte of an annealed WO3 thin film at 4 SCCM demonstrated high coloring efficiency of 20.06 cm2/C.
engineering, electrical & electronic,materials science, multidisciplinary,physics, applied