Abstract:In recent years, oxy-fuel combustion in coal-fired plants has become one of the most promising technologies for carbon capture and storage (CCS). Compared with air-fired combustion, high concentrations of CO2 and H2O in the flue gas cause a remarkable change in the pulverized coal combustion and heat transfer characteristics in furnace. In this study, improved models for the gas radiative properties and chemical reaction mechanisms were incorporated into the computational fluid dynamics (CFD) code to simulate a 200 MWe tangentially fired utility boiler, which is expected to operate at full load under both conventional air-fired and oxy-fuel combustion. Different flue gas recycle patterns: dry recycle and wet recycle, were also investigated. The results indicate that, stable combustion is achieved by a compatible burner design in both air-fired and oxy-fuel combustion. In the oxy-fuel combustion, the flue gas peak temperature and wall heat flux decrease and high CO concentration appears in the burner region, resulted from higher heat capacity of CO2 and chemical effect of CO2 (Liu et al., 2003, Glarborg and Bentzen, 2008). Based on the comparison of the wet recycle and dry recycle, it shows the wet recycle has more advantages than dry recycle. This study indicates a slight increase in total heat transfer, when the oxygen concentration in oxidant increases from 23% to 29%, consistent with the results of Vattenfall and Callide pilot scale oxy-combustion plant. Thus, compared with air-fired combustion, the full load of a boiler may decrease by 5-10% under oxy-fuel combustion. (C) 2014 Elsevier Ltd. All rights reserved.

Systematic numerical simulation and experimental study of gas-solid two-phase flow, heat transfer and combustion in W-shape flame boiler furnace

Numerical Simulation Of The Combustion Processes In A W-Shaped Boiler Furnace Under Different Operating Conditions

Study on coal combustion characteristics in a 350MW supercritical tangentially boiler

Numerical Simulation of the Flow and Combustion Processes in a Three-Dimensional, W-Shaped Boiler Furnace

Prediction Of Flow, Combustion And Heat Transfer In A Three-Dimensional, W-Shaped Boiler Furnace

Numerical Investigation on Oxy-Combustion Characteristics of a 200 MWe Tangentially Fired Boiler

Study on coal combustion characteristics in a W-shaped boiler furnace

Prediction on pulverized coal combustion process in the boiler using computer simulation

Numerical studies on the flow field in the tangential firing boiler furnace

Study on experiments and numerical simulation of coal combustion characteristics under different thermal environments

Numerical Simulation of Combustion and Pollution in a 330MW Opposed Firing Boiler

Numerical Simulation of Combustion Process for an 1000MW Ultra-Supercritical Boiler at Different Air Distribution Proportions

Simulation of Heat and Mass Transfer in a Moving Bed Part-fluidized Boiler

Numerical Simulation of the Effect of Combustion Process on Flue Gas Thermal Deviation in 660MW Boiler

Numerical Simulation of the Combustion and Pollution Emissions from a 75/th Circulation Fluidized Bed Boiler of Power Plant

Testing and Numerical Simulation of Temperature Field and Oxygen Field for CFB Boilers

Numerical simulation of the two-phase flow and combustion in the tangential-firing boiler furnace by using the ALE algorithm and trajectory model

Prediction on the Flame-stability and Slagging-prevention with Concentric Firing System using Computer-simulation

Experimental Research and Numerical Simulation on Combusting CWS in 410t/h Six-corner Tangentially Firing Boiler

Numerical and Experimental Study on Nonlinear Phenomena and Thermal Deviation Control in a 1000 MW Tower-Type Boiler

EXPERIMENTS AND NUMERICAL SIMULATION ON FLOW FIELD OF HEXAGONAL ARRANGED BOILER WITH A HIGH LENGTH-WIDTH RATIO DURING ABSENT-ANGLE RUNNING