Simulation of 3-D gas-particle flows andcoal combustion in a tangentially-fired furnace modelusing a two-fluid -traje ctory model
李力,周力行,李荣先,张健
DOI: https://doi.org/10.3969/j.issn.0258-1825.2001.01.005
2001-01-01
Abstract:Most of investig ators use Eulerian gas-phase model and particletrajectory model (Eulerian-Lag rangian) to simulate coal combustion in boiler furnaces. In this paper, a two-fluid-tra jectory (continuum-trajectory, CT) model (Eulerian-Eulerian-Lagrangian) is used for simulating turbulent reacting gas-particle flows and coal combustion in a tangentially fired furnace. It is based on Eulerian gas-phase equations, Eule rian particle-phase continuity and momentum equations and Lagrangian equations of particle temperature and mass change, with submodels of k-ε-kp two-ph ase turbulence model, EBU-Arrhenius turbulent combustion model, DO(discrete-ordina tes) radiation model, coal moisture evaporation,devolatilization and char combu stion models with simultaneous three reactions. To reduce the numerical diffusion caused by non-orthogonal crossing of the burner jets with the grid lines, acoordinate system rotated with an angle is adopted. To validate the two-phase fl ow models, an experimental study of the gas-particle flow field in a cold model of tangentially fired furnace was carried out using PDPA measurements, which gi ves the two-phase velocities, turbulence intensities and particle concentration .The comparison of cold two-phase flow predictions with measurements shows that the mean flow field is plausibly predicted. The 3-D coal combustion predictions give the hot-flow field, coal concentration distribution, the gas temperature, species concentration, and heat fluxes on the walls. The results show asymmet ric temperature distribution and a local high temperature zone near a sidewall at the furnace exit.