Abstract:The influence of temperature and strain rate on the hot tensile properties of 0Cr18AlSi ferritic stainless steel, a potential structural material in the ultra-supercritical generation industry, was investigated at temperatures ranging from 873 to 1123 K and strain rates of 1.7 × 10−4–1.7 × 10−2 s−1. The microstructural evolution linked to the hot deformation mechanism was characterized by electron backscatter diffraction (EBSD). At the same strain rate, the yield strength and ultimate tensile strength decrease rapidly from 873 K to 1023 K and then gradually to 1123 K. Meanwhile, both yield strength and ultimate tensile strength increase with the increase in strain rate. At high temperatures and low strain rates, the prolonged necking deformation can be observed, which determines the ductility of the steel to some extent. The maximum elongation is obtained at 1023 K for the strain rates of 1.7 × 10−3 and 1.7 × 10−2 s−1, while this temperature is postponed to 1073 K once decreasing the strain rate to 1.7 × 10−4 s−1. Dynamic recovery (DRV) and continuous dynamic recrystallization (CDRX) are found to be the main softening mechanisms during the hot tensile deformation. With the increase of temperature and the decrease of strain rate (i.e., 1123 K and 1.7 × 10−4 s−1), the sub-grain coalescence becomes the main mode of CDRX that evolved from the sub-grain rotation. The gradual decrease in strength above 1023 K is related to the limited increase of dynamic recrystallization and the sufficient DRV. The area around the new small recrystallized grains on the coarse grain boundaries provides the nucleation site for cavity, which generally results in a reduction in ductility. Constitutive analysis shows that the stress exponent and the deformation activation energy are 5.9 and 355 kJ·mol−1 respectively, indicating that the dominant deformation mechanism is the dislocations motion controlled by climb. This work makes a deeply understanding of the hot deformation behavior and its mechanism of the Al-bearing ferritic stainless steel and thus provides a basal design consideration for its extensive application.

The Mechanical Properties of Fe-36.5Al and Its Cr or Ti Containing Alloys at Elevated Temperature

Deformation behaviour of an FeAl Intermetallic alloy at elevated temperatures

The Mechanical Properties of Intermetallic Ni50−xTi50Alx Alloys (X=6,7,8,9)

Thermal Performance Determination of Binary Fe-Al Alloys at Elevated Temperatures

Mechanical Properties, Microstructure and Fracture Mechanism of 95W-3.5Ni-1.5fe Alloys at High Temperature

Anomalous Increase of Fracture Toughness of TiAl-based Alloys at High Temperature

High Temperature Tensile Property and Fracture Behavior of Directionally Solidified Fe-Al-Ta Eutectic Composites

SUPERPLASTICITY IN LARGE-GRAINED Fe-36.5Al BASED ALLOYS ADDED Ti

High Temperature Mechanical Properties and Deformation Mechanism of Equiaxed Fine-Grained Ti-45Al-7Nb Alloys

High Tensile Elongation of a Directionally Solidified NiAl Multiphase Alloy at High Temperatures

High-Temperature Mechanical Behavior of Cobalt-Free FeMnCrNi(Al) High-Entropy Alloys

On Phenomenon Of Superplasticity In Fe3al With Large Grains

Effect of temperature on mechanical properties of Al0.5CoCrCuFeNi wrought alloy

Microstructure and High Temperature Mechanical Properties of Powder Metallurgical Ti-45Al-7Nb-0.3W Alloy Sheets

Tensile Properties and Microstructural Evolution of an Al-Bearing Ferritic Stainless Steel at Elevated Temperatures

Tensile properties and fracture toughness of TiAl alloys with controlled microstructures

Tensile Properties of DD15 Single Crystal Superalloy at Different Temperature

Dynamic behavior and fracture mode of TiAl intermetallics with different microstructures at elevated temperatures

Thermal stability and mechanical properties of mechanically alloyed Al-10Ti alloy

Temperature-dependent Mechanical Properties and Fracture Behavior of Directionally Solidified Ti47Al2Cr2Nb Alloy

Mechanical properties, deformation behavior and microstructure evolution of Ti-43Al-6Nb-1Mo-1Cr alloys