Abstract:The high temperature tensile test of Ti-47.5Al-2.5 V-1.0Cr-0.2Zr alloy was carried out by electronic universal testing machine under the condition of 750–900 °C/10 −5 –10 −3 s −1 . The hot tensile stress-strain curves were analyzed, and the constitutive model under hot tensile conditions was established. The microstructure transformation rule and deformation mechanism during tensile process were determined. The results show that the hot tensile curve is longer in the steady-state flow stage corresponding to lower strain rate and higher tensile temperature, the true stress declines and the elongation at break increases. The constitutive equation was established based on the tensile curve data, and the corresponding thermal activation energy was 310.3 kJ/mol. As the rise of tensile temperature and the decline of strain rate, the proportion about cross-layer fracture in the tensile fracture morphology decreases, the number of dimples increases, more lamellar structures change into recrystallized structures, and the softening effect of the alloy is more obvious. The dislocation deformation mechanism mainly includes the existence of dislocation slip and climb, dislocation intersection and dislocation ring or dislocation network formation. Twinning deformation is also another important mechanism of high temperature tensile deformation of TiAl alloy. Twins are formed in parallel with each other, so that the deformation can be further carried out. The dislocations and twins in the deformed microstructure will provide nucleation conditions for recrystallized grains. The dynamic recrystallization(DRX) grains are preferentially formed around the grain boundary and the vicinity of dislocation and twin is also preferred nucleation site for DRX. The DRX behavior is the main softening mechanism, and DRX size and volume fraction corresponding to lower tensile rate and higher tensile temperature are larger.

Dynamic behavior and fracture mode of TiAl intermetallics with different microstructures at elevated temperatures

On revealing the mechanisms involved in brittle-to-ductile transition of fracture behaviors for γ-TiAl alloy under dynamic conditions

Microstructure Evolution of Near Gamma TiAl Intermetallic under Tensile Impact Loadings at High Temperatures

Temperature Effects on Deformation Substructures and Mechanisms of a Ni-based Single Crystal Superalloy

Investigation on the microstructure evolution and dynamic recrystallization mechanisms of TiAl alloy at elevated temperature

Microstructure evolution of a forged TiAl-Nb alloy during high-temperature tensile testing

Microstructure evolvement of isometry TiAl under tensile impact loadings

Hot Deformation Behavior of a Novel Near-β Titanium Alloy Ti-5.5Mo-6V-7Cr-4Al-2Sn-1Fe in (α+β) Phase Region

Tensile Impact Behavior and Deformation Mechanism of Duplex TiAl Intermetallics at Elevated Temperatures

Temperature-dependent Mechanical Properties and Fracture Behavior of Directionally Solidified Ti47Al2Cr2Nb Alloy

Study on high temperature tensile constitutive behavior and deformation mechanism of Ti-47.5Al-2.5 V-1.0Cr-0.2Zr alloy

Tensile impact behavior of duplex Ti-46.5Al-2Nb-2Cr at elevated temperatures

Strain rate effect on the tensile behavior of Duplex Ti–46.5Al–2Nb–2Cr intermetallics at elevated temperatures

The Mechanical Properties of Intermetallic Ni50−xTi50Alx Alloys (X=6,7,8,9)

Study of tensile properties and fracture mechanisms of fully lamellar TiAl based alloy

Tensile properties and fracture toughness of TiAl alloys with controlled microstructures

High temperature deformation behaviors of a high Nb containing TiAl alloy

Microscopic Investigation for Experimental Study on Transverse Cracking of Ti-Nb Containing Micro-Alloyed Steels

Breaking the high-temperature strength-ductility trade-off in TiAl alloys through microstructural optimization

Cyclic Deformation and Lattice Strain Distribution of High Nb Containing TiAl Alloy

Hot Deformation Behavior and Microstructural Evolution of a Novel β-Solidifying Ti-43Al-3Mn-2Nb-0.1Y Alloy