Abstract:Fiber-optic sensors have numerous existing and emerging applications spanning areas from industrial process monitoring to medical diagnosis. Two of the most common fiber sensors are based on the fabrication of Bragg gratings or Fabry-Perot etalons. While these techniques offer a large array of sensing targets, their utility can be limited by the difficulties involved in fabricating forward viewing probes (Bragg gratings) and in obtaining sufficient signal-to-noise ratios (Fabry-Perot systems). In this article we present a micro-scale fiber-optic force sensor produced using direct laser writing (DLW). The fabrication entails a single-step process that can be undertaken in a reliable and repeatable manner using a commercial DLW system. The sensor is made of a series of thin plates (i.e. Fabry-Perot etalons), which are supported by springs that compress under an applied force. At the proximal end of the fiber, the interferometric changes that are induced as the sensor is compressed are read out using reflectance spectroscopy, and the resulting spectral changes are calibrated with respect to applied force. This calibration is performed using either singular value decomposition (SVD) followed by linear regression or artificial neural networks. We describe the design and optimization of this device, with a particular focus on the data analysis required for calibration. Finally, we demonstrate proof-of-concept force sensing over the range 0-50 mu N, with a measurement error of approximately 1.5 mu N. Published by The Optical Society under the terms of the Creative Commons Attribution 4.0 License.

A Miniature Reflective Micro-Force Sensor Based on A Microfiber Coupler

Microfiber Optical Sensors: A Review

High-Sensitivity Microfiber Strain and Force Sensors

A Temperature Sensor Based on Optical Microfiber Knot Resonator

Femtoliter-scale Optical Nanofiber Sensors.

A Compact Sagnac Loop Based on a Microfiber Coupler for Twist Sensing

State-of-the-Art Optical Microfiber Coupler Sensors for Physical and Biochemical Sensing Applications

Optical Nanofiber-Enabled Self-Detection Picobalance

A nanonewton force sensor using a U-shape tapered microfiber interferometer

Supported Microfiber Loops for Optical Sensing.

Highly sensitive force sensor based on optical microfiber asymmetrical Fabry-Perot interferometer.

Miniature Fiber Pressure Sensor Based on an In-Fiber Confocal Cavity

Micro-scale fiber-optic force sensor fabricated using direct laser writing and calibrated using machine learning.

A compact microfiber coupler based Sagnac loop

A Novel Optical Fiber Reflective Read out Microcantilever Biosensor

Ampere Force Based Magnetic Field Sensor Utilizing a Microfiber Coupler

Measurement of Interfacial Adhesion Force with a 3D-Printed Fiber-Tip Microforce Sensor

A Miniature Force Sensor for Catheter Based on Optical Micro Deformation Detection

Mono-Fiber Optic Pressure Sensor

Ultra-small Microfiber Bragg Grating Force Sensor with Greater Sensitivity

Strain Force Sensor with Ultra-High Sensitivity Based on Fiber Inline Fabry-Perot Micro-Cavity Plugged by Cantilever Taper