Abstract:The transient process of a centrifugal pump existed in a variety of occasions. There were a lot of researches in the external characteristic in startup process and stopping process, but internal characteristics were less observed and studied. Study of the internal flow field had significant meanings. The performance of a pump could be evaluated and improved by revealing the flow field. In the other hand, the prediction of external characteristic was based on the correct analysis of the internal flow. In this paper, theoretical method and numerical simulation were used to study the internal characteristic of a centrifugal pump. The theoretical study showed that the relative flow in an impeller was composed of homogeneous flow and axial vortex flow. The vortex intensity was mainly determined by angular velocity of impeller, flow channel width and blade curvature. In order to get the internal flow field and observe the evolution of transient internal flow in the impeller, Computational Fluid Dynamics(CFD) were used to study the three-dimensional unsteady incompressible viscous flows in a centrifugal pump during starting period. The Dynamic Mesh (DM) method with non-conformal grid boundaries was applied to get the external characteristic and internal flow field. The simulate model included three pumps with different blade numbers and the same blade curvature. The relative velocity vector showed that there was a big axial vortex in impeller channel. At the beginning, the vortex was raised in the pressure side of the impeller outlet and with time went on, it shifted to the middle flow channel of the impeller and the vortex intensity increased. When the speed and flow rate reached a definite value, the influence of the axial vortex began to get smaller. The vortex developed faster when the flow channel got narrower. Due to the evolution of axial vortex, the slip factor during starting period was smaller than that in quasi-steady condition. As a result, transient head was lower than quasi-steady head in startup process.

Transient Characteristics of A Closed-Loop Pipe System During Pump Stopping Periods

Experimental And Numerical Studies Of Pump Transient Characteristics During Stopping Period

Analysis on Transient Performance of Mixed Flow Pump During Stopping Period

Numerical Simulation of the Transient Flow in a Radial Flow Pump During Stopping Period

Transient Hydraulic Performance of a Prototype Pump during Starting and Stopping Periods

Study on the Transient Characteristics of Pump During the Starting Process with Assisted Valve

THE TRANSIENT CHARACTERISTICS ANALYSIS OF PUMP DURING RAPID VALVE OPENING AND CLOSING

Transient flow analysis in axial-flow pump system during stoppage

Transient Internal Characteristic Study of a Centrifugal Pump During Startup Process

Analysis of Transient Force Performances of Pump-Turbine During Stop Process in Pump Mode

Experimental study on the coastdown process of a centrifugal pump

Steady and transient performance of a pump-turbine on an open-loop test rig: pump mode

Study On Transient Hydrodynamic Performance And Cavitation Characteristic Of High-Speed Mixed-Flow Pump

Numerical Study on Transient Performance of Mixed Flow Pump During Starting Period

Transient effect analysis of centrifugal pump during rapid starting period

Fluid-Structure Coupling Analysis of a Pump-turbine Unit During the Pump Shutdown Transient Process

Three-dimensional Transient Simulation of a Prototype Pump-Turbine During Normal Turbine Shutdown

Steady and transient performance of a model pump-turbine at off-design conditions: turbine mode

Experimental study on the transient characteristics and flows in a centrifugal pump during starting period

Transient Hydrodynamic Behavior of a Pump as Turbine with Varying Rotating Speed

Dynamic Interaction Between Valve-Closure Water Hammer Wave and Centrifugal Pump