Abstract:The transient process of a centrifugal pump existed in a variety of occasions. There were a lot of researches in the external characteristic in startup process and stopping process, but internal characteristics were less observed and studied. Study of the internal flow field had significant meanings. The performance of a pump could be evaluated and improved by revealing the flow field. In the other hand, the prediction of external characteristic was based on the correct analysis of the internal flow. In this paper, theoretical method and numerical simulation were used to study the internal characteristic of a centrifugal pump. The theoretical study showed that the relative flow in an impeller was composed of homogeneous flow and axial vortex flow. The vortex intensity was mainly determined by angular velocity of impeller, flow channel width and blade curvature. In order to get the internal flow field and observe the evolution of transient internal flow in the impeller, Computational Fluid Dynamics(CFD) were used to study the three-dimensional unsteady incompressible viscous flows in a centrifugal pump during starting period. The Dynamic Mesh (DM) method with non-conformal grid boundaries was applied to get the external characteristic and internal flow field. The simulate model included three pumps with different blade numbers and the same blade curvature. The relative velocity vector showed that there was a big axial vortex in impeller channel. At the beginning, the vortex was raised in the pressure side of the impeller outlet and with time went on, it shifted to the middle flow channel of the impeller and the vortex intensity increased. When the speed and flow rate reached a definite value, the influence of the axial vortex began to get smaller. The vortex developed faster when the flow channel got narrower. Due to the evolution of axial vortex, the slip factor during starting period was smaller than that in quasi-steady condition. As a result, transient head was lower than quasi-steady head in startup process.

Experimental study on the coastdown process of a centrifugal pump

Experimental And Numerical Studies Of Pump Transient Characteristics During Stopping Period

Experimental and numerical investigations on pressure pulsation in a pump mode operation of a pump as turbine

Transient flow analysis in reactor coolant pump systems during flow coastdown period

Study on the Characteristics of the Nuclear Reactor Coolant Pump During the Process-Divided Start-Up Period

Study on the Transient Characteristics of Pump During the Starting Process with Assisted Valve

Transient Internal Characteristic Study of a Centrifugal Pump During Startup Process

Fluid-Structure Coupling Analysis of a Pump-turbine Unit During the Pump Shutdown Transient Process

Transient Hydraulic Performance of a Prototype Pump during Starting and Stopping Periods

Study on the Four-Quadrant Homologous Characteristic and Two-Phase Flow Head Degradation of a Reactor Coolant Pump

Numerical Study of Hydraulic Axial Force of Prototype Pump-Turbine Pump Mode's Stop with Power Down

Transient flow analysis of pool-type reactor coolant pump under flow coast-down

Numerical investigation on characteristics of transient process in centrifugal pumps during power failure

Investigation of Unsteady Pressure Pulsations of Reactor Coolant Pump Passage under Flow Coast-down

Analysis of Pressure Pulsation Induced by Rotor-Stator Interaction in Nuclear Reactor Coolant Pump

Experimental Study on Hydrodynamic Performance of A Cavitating Centrifugal Pump During Transient Operation

Transient flow analysis in axial-flow pump system during stoppage

The transient flow in a centrifugal pump during the discharge valve rapid opening process

Experimental And Numerical Simulation On The Starting Period Of A Centrifugal Pump

Experimental study on the transient characteristics and flows in a centrifugal pump during starting period

Numerical Simulation of the Transient Flow in a Radial Flow Pump During Stopping Period