Abstract:Hydropower has been the leading renewable source and cheapest ways to generate electrical energy in the world. In recent years, there has been a major upsurge in the hydropower development because of the use of pump as turbine (PAT). However, the operational reliability of a PAT is greatly affected by the unsteady flow fields; therefore, it is important to examine the unsteady flow behavior which can be used as a reference to reduce the noise, vibration, and cavitation performance for centrifugal pumps working as turbines. Thus, the objective of this study was to evaluate the unsteady flow fields by analyzing the distribution of the pressure pulsations using both numerical and experimental measurements in a PAT operating in pump mode. Firstly, the three‐dimensional (3D) unsteady flow equations were solved using SST <i>k‐</i>ω turbulence model during the numerical calculations. Secondly, the numerical results of the hydraulic pump performance were validated by the experimental measurements for numerical accuracy. Lastly, pressure transducers are positioned at certain monitoring points to measure the pressure in the PAT investigated. The numerical and experimental results show that the main frequency of the pressure pulsation is equal to the blade frequency, and as it deviates from the design operating condition, the magnitude of pressure pulsation intensifies. Furthermore, the impeller eye marked the lowest pressure coefficients especially at the design condition and makes it highly susceptible to cavitation. High pressure coefficients were obviously seen at the pressure side on the blade surface closer to the trailing edge at all studied operating conditions. Meanwhile, the rotor‐stator interaction generated the highest pressure pulsation distribution at the volute tongue. Thus, modification of the volute tongue is an optimal approach of reducing the pressure pulsation intensity in the volute and pump as a whole.

Dynamic Interaction Between Valve-Closure Water Hammer Wave and Centrifugal Pump

A Simulation Study of Hydraulic Vibration caused by Clearance Flow in a Pump Turbine

Analysis of axial force and pressure pulsation of centrifugal pump as turbine impeller based on dynamic mode decomposition

Experimental and numerical investigations on pressure pulsation in a pump mode operation of a pump as turbine

Three-dimensional computational fluid dynamics simulation of valve-induced water hammer

Study on Vibration Characteristics of Fracturing Piping in Pump-Starting and Pump-Stopping Water Hammer

Dynamic Behaviors of Blade Cavitation in a Water Jet Pump with Inlet Guide Vanes: Effects of Inflow Non-Uniformity and Unsteadiness

Numerical Simulation and Optimization on Valve-Induced Water Hammer Characteristics for Parallel Pump Feedwater System

Quantitative Analysis of Energy Loss and Vibration Performance in a Circulating Axial Pump

Numerical Simulation of the Water Hammer Caused by Accidental Pump-stop in Long Water Supply Systems

Experimental and Numerical Studies on Erosion Damage in Damping Holes on the Valve Plate of an Axial Piston Pump

A study of the numerical simulation of water hammer with column separation and cavity collapse in pipelines

Research of Fluid-Induced Pressure Fluctuation Due to Impeller-Volute Interaction in A Centrifugal Pump

Research on Cavitation Wake Vortex Structures Near the Impeller Tip of a Water-Jet Pump

Cross-influence of cavitation and flow rate on pressure pulsation of a volute mixed flow pump

An Experimental Study on the Water Hammer with Cavity Collapse under Multiple Interruptions

Experimental and Numerical Research on Fluid Dynamic Interaction Effects of Reciprocating Pump–Pipeline System

Moc-Cfd Coupled Approach for the Analysis of the Fluid Dynamic Interaction Between Water Hammer and Pump

Analysis of State-Changing Water Hammer in A Long Pipe

Transient Characteristics Analysis of Water Hammer Phenomena Based on Coupling Program

Influence of impeller-tongue interaction on the unsteady cavitation behavior in a centrifugal pump