Abstract:The transient process of a centrifugal pump existed in a variety of occasions. There were a lot of researches in the external characteristic in startup process and stopping process, but internal characteristics were less observed and studied. Study of the internal flow field had significant meanings. The performance of a pump could be evaluated and improved by revealing the flow field. In the other hand, the prediction of external characteristic was based on the correct analysis of the internal flow. In this paper, theoretical method and numerical simulation were used to study the internal characteristic of a centrifugal pump. The theoretical study showed that the relative flow in an impeller was composed of homogeneous flow and axial vortex flow. The vortex intensity was mainly determined by angular velocity of impeller, flow channel width and blade curvature. In order to get the internal flow field and observe the evolution of transient internal flow in the impeller, Computational Fluid Dynamics(CFD) were used to study the three-dimensional unsteady incompressible viscous flows in a centrifugal pump during starting period. The Dynamic Mesh (DM) method with non-conformal grid boundaries was applied to get the external characteristic and internal flow field. The simulate model included three pumps with different blade numbers and the same blade curvature. The relative velocity vector showed that there was a big axial vortex in impeller channel. At the beginning, the vortex was raised in the pressure side of the impeller outlet and with time went on, it shifted to the middle flow channel of the impeller and the vortex intensity increased. When the speed and flow rate reached a definite value, the influence of the axial vortex began to get smaller. The vortex developed faster when the flow channel got narrower. Due to the evolution of axial vortex, the slip factor during starting period was smaller than that in quasi-steady condition. As a result, transient head was lower than quasi-steady head in startup process.

THE TRANSIENT CHARACTERISTICS ANALYSIS OF PUMP DURING RAPID VALVE OPENING AND CLOSING

Dynamic analysis of the pump system based on MOC–CFD coupled method

Study on the Transient Characteristics of Pump During the Starting Process with Assisted Valve

Moc-Cfd Coupled Approach for the Analysis of the Fluid Dynamic Interaction Between Water Hammer and Pump

Study On Transient Hydrodynamic Performance And Cavitation Characteristic Of High-Speed Mixed-Flow Pump

Transient Internal Characteristic Study of a Centrifugal Pump During Startup Process

Model Analysis and System Parameters Investigation for Transient Wave in a Pump–Pipe–Valve System

Numerical Study on Transient Performance of Mixed Flow Pump During Starting Period

Study on the Transient Characteristics of the Centrifugal Pump during the Startup Period with Assisted Valve

Modeling and Dynamic Characteristics Analysis on a Three-Stage Fast-Response and Large-Flow Directional Valve

The transient flow in a centrifugal pump during the discharge valve rapid opening process

Sensitivity Analysis of Operational Time Differences for a Pump–Valve System on a Water Hammer Response

The Research of 1D / 3D Coupling Simulation on Pump and Pipe System

Dynamic Interaction Between Valve-Closure Water Hammer Wave and Centrifugal Pump

Transient Simulation of Valve Core Movement of Pilot-Control Globe Valve in Vertical Pipelines

TRANSIENT SIMULATION ON UNBALANCED TORQUE OF PISTON TYPE VALVE CORES DURING DYNAMIC MOTION

Steady and transient performance of a model pump-turbine at off-design conditions: turbine mode

Numerical Simulation on Pump Transient Characteristic in a Model Pump Turbine

3D CFD simulation and analysis of transient flow in a water pipeline

Numerical analysis of the transient characteristics of internal flow in the acceleration process of variable speed regulation of a centrifugal pump

Analysis of Flow Characteristics of a Pump Turbine under the Transient Condition of 75% Load Rejection