Abstract:Deformation measurement and control is a critical challenge in metal additive manufacturing. The metal deposition and solidification occur under the condition of high temperature gradient and large restriction accompany with complex metallurgical phenomena and stress evolutions. High stresses may result in deformation over yield strength of material, or even crack and fracture over the ultimate strength. Thus, it is necessary to monitor the deformation during additive manufacturing process. This paper focus on an in situ measurement of full-field deformation for arc-based directed energy deposition process via digital image correlation (DIC) technology. The measurement qualities were evaluated from the following aspects including system error, speckle pattern, influence of arc light and comparison in 2D-DIC and 3D-DIC. Results indicated that the relative system error of the measured deformation is no more than 0.12 % within a total deformation of 12 mm. Both the artificial speckle and natural speckle can meet the requirement of 2D-DIC system. The image qualities for artificial speckle is higher than that of natural speckle. For 3D-DIC, however, artificial speckle must be applied. The moving arc light will weaken the image qualities, which must be shielded in order to prevent the interference of intense light and the damage of speckle. An L -type shield was proposed and proved to be practical. Finally, DIC measuring was applied in both single-wall and cylindrical AM parts, comparing with numerical simulation. Results indicated that the evolution of the measured deformations showed good agreement with that of numerical simulation. Deformation evolution mechanism was revealed through numerical simulation and the evolution process was divided into three stages. For the cylindrical part, the final outer contour measured by DIC was consistent with that of 3D laser scanning and numerical simulation. As a conclusion, DIC technology was proved to be a feasible approach for in situ monitoring of full-field deformation of arc-based directed energy deposition process.

Study on the Effect of DIC Deformation Sensor on Mechanical Property of Substrate

Fabrication of a DIC Sensor for In-Plane Deformation Measurement

DIC/DSI Based Studies on the Local Mechanical Behaviors of HR3C/T92 Dissimilar Welded Joint During Plastic Deformation

Elastic Property Characterization of Soft Substrate-Supported Thin Films Using Multiscale Digital Image Correlation

Measuring large tensile deformation of polymers using fluorescent 3D-digital image correlation with adaptive incremental calculation strategy

Surface Patterning for Multi-Scale Strain Analysis of In-Situ Sem Mechanical Experiments

Study on the Mechanical Behavior of Adhesive Interface by Digital Image Correlation

Application of Digital Image Correlation (DIC) to the Measurement of Strain Concentration of a PVA Dual-Crosslink Hydrogel Under Large Deformation

Strain Measuring of Composite Grid Using Digital Image Correlation

Surface Patterning for Combined Digital Image Correlation and Electron Backscatter Diffraction In-Situ Deformation Experiments

Measurement of Coefficient of Thermal Expansion of Films Using Digital Image Correlation Method

A new mark shearing technique for strain measurement using digital image correlation method.

Full field and microregion deformation measurement of thin films using electronic speckle pattern interferometry and array microindentation marker method

Quantifying surface deformation around micrometer-scale indents by digital image correlation

Effects of Various Shape Functions and Subset Size in Local Deformation Measurements Using Dic

In situ measurement of full-field deformation for arc-based directed energy deposition via digital image correlation technology

Model-Based Digital Image Correlation for Noncontact Deformation Measurement of Strain Field and Mechanical Property

Using Digital Image Correlation on SEM Images of Strain Field after Ion Beam Milling for the Residual Stress Measurement of Thin Films

A 2D mark shearing technique for characterizing the mechanical properties of material

Time-Resolved Digital Image Correlation in the Scanning Electron Microscope for Analysis of Time-Dependent Mechanisms

A Feasible Surface Patterning Method for SEM-DIC: Achieving High-Resolution In Situ Mapping of Local Strain and Microstructure to Reveal the Effect of Slip Transfer on Shear Strain Near Grain Boundaries