Abstract:Digital image correlation (DIC) method is a novel non-contact full field optical method for the measurement of deformation of specimens. Compared to the conventional methods for the deformation measurement that usually involve sensors being directly in contact with the samples, the DIC method has some advantages of easy operation, large scale and high accuracy deformation measurement, and flexible selection of the analysis area, etc.. In addition, polymer latexes are widely used in cementitious materials to improve their toughness and impermeability. This paper was to apply the DIC method to investigate the mechanical properties of polymer modified mortar (PMM). The full stress-strain curves of PMMs at different polymer contents were obtained under a compressive load by the DIC method and the conventional contacting method. The results show that besides the full stress-strain curves, the DIC method provides the additional information on cracking and fracturing of the specimens, which is more advantageous than the contacting methods. Compared to the full stress-strain curves obtained by the DIC method and the contacting method, the strain provided by the DIC methods that represents the deformation of the selected intermediate testing area is generally lower than that measured by the contacting method at a given stress load, which stands for the deformation of the whole sample. This phenomenon is due to the constriction effect of the surroundings for the selected intermediate testing area. A greater polymer content reduces the constriction effect of the surrounding material to the intermediate part. The failure mode of polymer modified mortar changes from brittle failure to ductile failure when the polymer content increases. Moreover, the 1st crack strain, peak strain and fracture energy of polymer modified mortar increase with the increase of polymer content.At low polymer dosages (i.e., <5％), the Poisson ratio of polymer modified mortar increases with the increase of polymer content.

A 2D mark shearing technique for characterizing the mechanical properties of material

A new mark shearing technique for strain measurement using digital image correlation method.

DIC/DSI Based Studies on the Local Mechanical Behaviors of HR3C/T92 Dissimilar Welded Joint During Plastic Deformation

Application of digital image correlation to measurement of packaging material mechanical properties

Surface Patterning for Multi-Scale Strain Analysis of In-Situ Sem Mechanical Experiments

Two-dimensional digital image correlation for in-plane displacement and strain measurement: a review

Application of 3D digital image correlation for the measurement of the tensile mechanical properties of high-strength steel

Full-Field Strain Measurement Based on Least-Square Fitting of Local Displacement for Digital Image Correlation Method

A New Micro-Tensile System for Measuring the Mechanical Properties of Low-Dimensional Materials - Fibers and Films

An Internal Digital Image Correlation Technique for High-Strain Rate Dynamic Experiments

Application of Digital Image Correlation for Strain Mapping of Structural Elements and Materials

Two-Dimensional Meshfree-Based Digital Image Correlation for Strain-Displacement Measurement

Full-field Analysis of Shear Test on 3D Orthogonal Woven C/C Composites

Measuring large tensile deformation of polymers using fluorescent 3D-digital image correlation with adaptive incremental calculation strategy

A Feasible Surface Patterning Method for SEM-DIC: Achieving High-Resolution In Situ Mapping of Local Strain and Microstructure to Reveal the Effect of Slip Transfer on Shear Strain Near Grain Boundaries

High-accuracy Optical Extensometer Based on Coordinate Transform in Two-Dimensional Digital Image Correlation

BRIEF INTRODUCTION OF DIGITAL SPECKLE CORRELATION METHOD FOR NON-CONTACT STRAIN MEASUREMENT

An Apparatus for Measuring Mechanical Properties of Microstructures in Tensile Mode

A Measuring System for Mechanical Characterization of Thin Films Based on a Compactin Situmicro-Tensile Tester and SEM Moiré Method

Envelope Element Local Digital Image Correlation Method for Crack Tip Deformation Field Measurement

Application of Digital Image Correlation Method in Mechanical Properties Test of Polymer Modified Mortar